Walker Bay 275R, 275H Assembly Instructions Manual
RID™:275R, 275H Assembly Instructions
Walker Bay Boats Inc. 717 Butterfield Rd, Yakima, WA 98901, USA
Toll Free Phone (U.S.A & Canada) 1-888-44WALKER (449-2553) or 604-682-5699 Fax (U.S.A & Canada) 1-888-228-7222 or 604-683-1877
web: www.walkerbay.com email: info@walkerbay.com
RID Kit Part #91701 Instruction Book Part #14031 Rev #SR.01.16.06
®
PARTS LIST
(Specifications and contents subject to change without notice)
Description Part #
A. RID Track......................................................... #17326
B. Connection Plate.............................................. #1111 0
C. Bolts (10-32 x 3/4”) .......................................... #11122
D. Bolts* (10-32 x 5/8”)......................................... #11043
E. Rubberback Washers* (#12 )........................... #11076
F. Nylock Nuts* (10-32) ....................................... #11067
G. RID Tube
275R:...................................................................... #17340
275H:...................................................................... #17353
H. Davit Lifting Eyebolts (with washer & nut) ....... #21021
I. Pump ............................................................... #91601
J. Repair Kit (with valve wrench) ......................... #975000
K. Capacity Plate.................................................. #10053
*Extra bolt, washer & nut included for convenience.
!
$
&
!
% &
"
Bow Section Aft Section
Fasten nut tightly
4%-0,!4%
4%-0,!4%
Tools you will need:
Remove paper template.
Drill with bit #11
Screwdriver
RETROFIT RID TRACK ASSEMBLY INSTRUCTIONS FOR NON RID READY BOATS
Cut out template on corner of page.
Align port (left) template with outside of
port gunwale lip and first rib on aft edge.
Using a drill gun & bit #11, drill first
hole. Be careful to drill hole perpendicular to hull.
Insert bolt and washer from inside
boat. From outside, attach nut
loosely, do not tighten yet.
Align track with gunwale lip and drill
remaining holes to match pre-drilled
holes in track.
Insert bolts & washers for each hole,
attaching nut loosely.
With both tracks in place, drill holes for bow track as in step 6.
Once all nuts & bolts are in place on forward track, tighten all nuts
working from bow to center, then aft to centre.
Repeat steps 1 through 10 on starboard (right) side of boat.
At 4th hole (track end), fit rectangular
washer onto track.
Use bolt identified as CONNECTION
HARDWARE.
Slide bow and aft track section with
washer in place until they touch
connecting bolt.
Align last hole in track
with hole drilled on boat.
#
!
On assembled boat, locate RID plugs along each
side of the hull. Gently tap RID plugs out with a
hammer.
Once RID plugs are dislodged,
carefully pry plugs out with claw of
hammer
To secure track to hull, insert bolt and washer
from inside of hull and nut from outside of hull.
Rear Track, Port Aft
Front Track, Port Bow
RID TRACK ASSEMBLY INSTRUCTIONS FOR RID READY BOATS
$
% &
Loading...