Walka Handheld TV User Manual

USER GUIDE 1.2

HANDHELD TV

23

Contents

Introduction

Walka Handheld TV

Walka Components

Charging your Walka

Activate your Walka

Basic Functions

Advanced

Functions

Settings

Aspect Ratio

Channel Scan

Resetting your Walka

Updating the rmware

Setting the Time Zone

4

5

6

10

11

13

15

17

18

19

20

22

23

Setting the Time Zone

Please note that the default time zone in set for South Africa.
To change your time zone settings do the following;

1. Click on the menu/ button.

2. Using the channel up/down buttons to select the settingsmenu item.

3. Click on time zone.

4. Select the time zone for the country that you are located in.

5. Click okay to accept.

6. Click on the menu/ button to exit the menu.

DStv Mobile Terms & Conditions

Must be accepted to use this device. You can view the terms and
conditions and/or the end user licence agreement by doing the
following;

1. Go to apps.dstvmobile.com/decoder/terms

2. Email [e-mail]

3. Visit your local DStv service centre and request a copy of the

subscription terms & conditions or Walka end user licence
agreement.

GOtv Mobile Terms & Conditions

GOtv Mobile terms & conditions and the end user licence agreement
can be found at www.gotvafrica.com

13

22 3

Updating the Firmware

1. On your computer go to dstvmobile.com or gotvafrica.com, select
the country you are located in from the available map or drop down
menu.

2. Click on the get DStv Mobile/get GOtv Tab, then click on phones
and devices.

3. Locate the Walka on the list of devices and then click on read more.

4. Scroll to the bottom of the page and click on download rmware.

5. Save the rmware to your computer.

6. Turn on the Walka.

7. Short click on the menu/ button to access the settings menu, then

click on Settings.

8. Scroll down and select the rmware upgrade option.

9. Follow the on-screen instructions.

10. Once the rmware upgrade is complete the Walka will restart.

214

!

Factory Reset (Hard reset)

In the event that the soft reset does not work, then it might be necessary

to perform a factory reset. To do this, hold down the power button for 5
seconds while inserting a paper clip into the reset hole on the left of the
device. Then release the power button and remove the paper clip from
the reset hole. The device will power up and you will see the ‘Walka’
screen. Accept the terms and conditions and the device will perform a
channel scan.

Introduction

Welcome to the exciting world of mobile broadcast TV. You can use
your Walka to access and view DStv Mobile or GOtv Mobile broadcast
content within the broadcast coverage area. This guide will help you
operate your Walka.