Wald BICYCLE BASKET Assembly Instructions Manual
BICYCLE BASKET
BICYCLE BASKET
with handle & mounting holder
- Basket easily removed for carrying
- Sized for grocery bag & many other uses
- Rust resistant durable finish
- Extended Mounting Holder allows clearance for shifters, brake
levers & cables
5
LOCK END
4
7
3
1
BRACE
6
LONG SCREW
2
MOUNTING
HOLDER
HOLDER SLOT
HOLDER
TOP BRACKET
HANDLEBAR
CLAMP
MOUNTING HOLDER
BOTTOM HOOKS
with handle & mounting holder
- Basket easily removed for carrying
- Sized for grocery bag & many other uses
- Rust resistant durable finish
- Extended Mounting Holder allows clearance for shifters, brake
levers & cables
5
LOCK END
4
7
3
1
BRACE
6
HOLDER SLOT
HOLDER
TOP BRACKET
HANDLEBAR
CLAMP
MOUNTING HOLDER
BOTTOM HOOKS
ASSEMBLY INSTRUCTIONS
- Loosely assemble 1brace onto two vertical side wires of
2
holder with short screws. In most cases brace will be angled
upward toward Stem as shown.
- Center holder and hang
(If clamping onto 7/8" portion of handlebar, insert rubber spacer
strips between holder and handlebar). Loosely assemble two
4
handlebar clamps with long screws.
- Attach basket to holder
- Hold basket so
- Center basket with holder and insert lower basket frame wire over
bottom hooks of holder as shown.
- Raise handle upright and insert
7
slot at top of holder.
- Lay handle flat to lock.
- Adjust holder
is in proper position.
- Remove basket from holder
- Raise basket handle upright.
- Pull away from holder and lift basket from bottom hooks of holder.
- Tighten all holder fittings securely.
SHORT SCREW
3
holder top brackets over handlebar.
5
lock end of handle is toward holder.
5
lock end of handle through
1
brace vertically on holder side wires until basket
!
WARNING
DO NOT
overload basket.
Overloading basket may cause difficulty
in steering and/or loss of bicycle control
which could result in injury.
Mfgr.No.3133
Made in U.S.A. by Wald
C
2009 Wald LLC
Rev.A 4/8/2009
GB (Black)
ASSEMBLY INSTRUCTIONS
- Loosely assemble 1brace onto two vertical side wires of
2
holder with short screws. In most cases brace will be angled
upward toward Stem as shown.
- Center holder and hang
(If clamping onto 7/8" portion of handlebar, insert rubber spacer
strips between holder and handlebar). Loosely assemble two
4
handlebar clamps with long screws.
- Attach basket to holder
- Hold basket so
- Center basket with holder and insert lower basket frame wire over
bottom hooks of holder as shown.
- Raise handle upright and insert
7
slot at top of holder.
- Lay handle flat to lock.
- Adjust holder
1
brace vertically on holder side wires until basket
is in proper position.
- Remove basket from holder
- Raise basket handle upright.
- Pull away from holder and lift basket from bottom hooks of holder.
- Tighten all holder fittings securely.
3
5
lock end of handle is toward holder.
Loading...