Wahl EAR-NOSE-BROW User Manual

EAR-NOSE-BROW TRIMMER

Instructions

INSTALLATION/ REMOVAL OF TRIMMING
HEADS

SIDEBURNS AND MUSTACHE

Make sure trimmer unit is turned “OFF”.
1 Turn trimmer head
counterclockwise 1/4
turn and lift off.
2 Place trimmer head
on trimmer and turn
trimmer head clockwise
1/4 turn to lock on.

TRIMMING NOSE HAIR

Make sure the nasal passages are clean. Slowly
move the rotary blade/detailer in and out of each
nostril, no more than 1/4-inch deep.

TRIMMING EAR HAIR

Make sure the outer areas of the ears do not con­tain any wax. Hold the ear flat with one hand and
carefully insert rotary blade/detailer no more than
1/4-inch into the outer ear. CAUTION: Do not insert
the rotary blade/detailer or any other foreign object
into the inner ear. For hair growing on the outside
of the ear, simply move the rotary blade/detailer
slowly along the edges of the ear.

TRIMMING EYEBROWS

Slowly move rotary blade/detailer to neatly trim
stray hairs. For precise, even trimming, slowly
move the rotary blade/detailer closer or farther
away from eyebrows to achieve desired length.

TRIMMING WITH EYEBOW ATTACHMENT
COMB

To install eyebrow attachment
comb, you must use the recipro­cating head and place eyebrow
attachment comb over it. The
attachment comb allows you to
trim and shape eyebrows. Trim
by following in the direction of
hair growth.

For detailing sideburns and
mustache, use detailing head
across desired areas. For
trimming sideburns slowly
move detailing head across
desired area.

TRIMMING PRIVATES

For hard to reach or tight areas, use the detailer
head. Slowly move the detailer through area to trim
until desired look is accomplished.

TROUBLESHOOTING

If your Trimmer does not seem to take a charge,
check the following before returning it for repair:

1. Check outlet current by plugging in another
appliance.

2. Make sure the outlet simply is not connected to a
light switch which turns the power at the outlet off
when lights are turned off.

3. Be sure the trimmer is properly connected to the
recharging transformer, all connections are secure
and the switch on the trimmer is turned “OFF - 0.”

4. If your electricity is connected to a master power
switch, we suggest the trimmer be disconnected
from the charger anytime the master switch is off.
Leaving the unit plugged into a dead outlet or an
unplugged charger will drain the battery.

5. If trimmer does not run and it is completely
charged, turn the unit “ON - I” and pinch or push
the blades manually. (Oil may have dried out
between the blades, so they may be temporarily
stuck together.)
For the cleaning and care instructions of your
trimmer, please download the Care Instructions.

SERVICE AND REPAIR

If you have problems with your WAHL product, send

it prepaid with a note explaining the problem to:

Wahl Clipper Corporation

Attn: Repair Department

3001 Locust Street

Sterling, IL 61081

Telephone [phone]

For products purchased outside the United States,

contact your distributor.