Wago all printers Instruction Manual

Information on Handling Print Material

WAGO is a registered trademark of WAGO Verwaltungsgesellschaft mbH.

Information on Print Material

Note: Individual information on handling print material are representative of other print materials with
identical handling. The graphics in these notes only represent the print material to be named.

Information on Handling Print Material 004/08.2017 1

Information on Handling Print Material

WAGO is a registered trademark of WAGO Verwaltungsgesellschaft mbH.

Use roller item number 258-5006.

The tip of the triangle in the housing
and the tip of the triangle on the sensor
must point directly towards each other.

Set the guide to the print material
width.
Optimum setting:
1 mm + print material width + 1 mm

1. Hardware Preparation

1.1 Roller

1.2 Sensor Settings

1.3 Load the Print Material and Align It

Information on Handling Print Material 004/08.2017 2

Information on Handling Print Material

WAGO is a registered trademark of WAGO Verwaltungsgesellschaft mbH.

Figure 2.2: The information area shows
results for the print material

Figure 2.1: GoDoctor dialog box

❶

❷

2. GoDoctor – Measure the Print Material Dimensions

GoDoctor printer software

Always use the most up-to-date version of the software. Check your existing installation to make sure that it is
up to date, or download the newest version.

The program file GoDoctor.exe can be found in the smartSCRIPT installation directory on your PC / laptop.

C:/Programme(86)/Wago/smartScript/…

Notice: The [Factory Default] button resets the printer to factory settings.

All individual bits of information (this includes network settings) will be deleted!
Press [Reset Printer] ❶. Wait until the bar of the progress indicator in the display has gone through. The

current print media settings are deleted. The end of the process is confirmed after 20 seconds, by a simple
acoustic signal.
Press [Auto-Calibration] ❷. Material will be fed through the printer!
Figure 2.2 shows the info area in the GoDoctor dialog box with the correct information in line 1 and 4 on the
print material after auto-calibration.

Important:

Auto-calibration has failed if the information in the info area deviates from the information shown in
Figure 2.2.
Check the sensors setting and run auto-calibration again.
Contact our support team if doing this does not yield the results shown in the image.

Information on Handling Print Material 004/08.2017 3

Information on Handling Print Material

WAGO is a registered trademark of WAGO Verwaltungsgesellschaft mbH.

❹

❸

❶

❷

Figure 3.1: WAGO-printer-settings

Figure 3.2: Instructions dialog box for driver

3. WAGO-Printer-Settings - Set Printer Settings

WAGO-Printer-Settings

Always use the most up-to-date version of the software. Check your existing installation to make sure that it is
up to date, or download the newest version.

Start the WAGO-printer-settings.

In the [Installed Printer] ❶ window, choose the WAGO smartPRINTER.
Open the [Options] menu ❷ and deactivate [Autosensing].
Select the directory ❸.
Select the print material ❹.

The specific printer settings for the article are transferred to the smartPRINTER as soon as you select the print
material.
Press [OK] to confirm the following instructions dialog box (Figure 3.2).

The smartPRINTER is now properly set up for the print material.

Information on Handling Print Material 004/08.2017 4