Wagan Slim Line, Slim Line 2016-6 User Manual

R

Item no. 2016-6

Slim Line 700 Watt

USB Inverter

User’s Manual

R

Slim Line 700 Watt USB Inverter by Wagan Tech

2

User’s Manual—Read before using this equipment

©2010 Wagan Corporation. All Rights Reserved.

Wagan and wagan.com are trademarks used by Wagan Corporation.

3

Thank you for purchasing the Slim Line 700 Watt USB Inverter. With minimal
care and proper treatment it will provide years of reliable service. Please read
and understand all operating instructions carefully before use.

Your 700 Watt USB Power Inverter converts 12V DC battery power to 115V
AC household electrical power. You use the inverter in your vehicle to operate
many types of appliances that use AC or USB power, such as TVs, VCRs,
portable computers, power tools and lights for emergency or camping use.

The inverter works with your vehicle’s engine turned on or off (accessory mode).
It provides a continuous output of up to 700 Watts.

DESCRIPTION

1800W Peak Power: Allows you to power appliances that require a large

amount of initial (peak) power to work (such as many televisions or motorized
equipment).

Low Battery Alarm: The inverter sounds an audible alarm, then turns itself off

if the source battery becomes too low.

Auto Shutdown / Reset Protection: The inverter temporarily shuts itself down

to protect itself from overheating.

Overload / Short Circuit Protection: The inverter automatically turns itself off

if the connected load is too high or if it shorts.

Fuse: The inverter comes with fuse(s) already installed and are easily

changeable if damaged. The blade fuses (similar to those in a vehicle) are
located inside the unit. Please turn off and disconnect all the cable connections.
Open one side of the unit by unscrewing the screws and slide off the metal
cover. Check the condition of each of the blade fuses. If it is burnt, please
change it according to the Amp indicated on the blade fuse. These can be
purchased at your local automotive parts store.

Dual AC Outlets: Allows you to power up to two AC appliances.

Dual USB Outlets: Allows you to power up to 2 USB appliances.

CAUTION

• DO NOT USE THE INVERTER IN A POSITIVELY GROUNDED VEHICLE.

• THE ELECTRICITY GENERATED BY THE INVERTER IS MODIFIED SINE
WAVE. Do not use the inverter to power the following devices:

» Small appliances such as rechargeable flashlights, some razors,

and some rechargeable night lights that plug into a wall outlet for
recharge.

» Some battery chargers for rechargeable tools.

• Before using the inverter, please check the equipment manufacturer’s
manual and specifications to check if the equipment is capable of being
charged properly without damaging it.

WARNINGS

• Shock hazard: The Inverter generates the same AC power as a normal
household wall outlet.

• Do not attempt to open or disassemble unless instructed by technical
service personnel.

• Do not insert foreign objects into the outlet.

• Do not expose to water, rain or snow.

• Do not connect to power utility AC distribution wiring.

• Heated surface: The inverter housing may become uncomfortably warm,
reaching 65°C (150°F) under extended high power operation.

• During operation, keep the inverter from materials that may be affected
by high temperatures.

• Failure to follow the above may result in personal injury or damage to
the inverter.

R

+

+

Battery

USB Electronics

AC Appliance

Inverter

Sine Wave Modified Sine Wave (MSW)

Slim Line 700 Watt USB Inverter by Wagan Tech

4

User’s Manual—Read before using this equipment

©2010 Wagan Corporation. All Rights Reserved.

Wagan and wagan.com are trademarks used by Wagan Corporation.

5

BASIC OPERATION

Note: Use the right operating voltage for both input and output of the inverter.

Connecting to Power Source (Directly to a 12V DC battery):

1. Unscrew the red and black terminal covers of the inverter.

2. Attach the red, positive (+) wire to the positive terminal. Secure
the wire with the terminal cover.

3. Attach the other end of the wire to the red, positive (+) terminal
of the battery.

4. Repeat the previous 2 steps with the black, negative (−) terminal
and matching black wire.

CONNECTING AND USING AC APPLIANCES

1. Plug an AC product into the three prong AC receptacle and/or a USB
powered appliance into one of the USB power sockets and turn the
inverter on. The green LED will light up. Ensure the total power of all your
products draws 700 watts or less of continuous AC power.

2. To avoid discharging the battery power source, always turn the power
inverter off and disconnect the inverter from the power supply when not
in use.

3. Disconnect the inverter from a vehicle when starting the engine.

4. If the inverter makes a beeping sound, turn off the inverter and
disconnect all appliances from the inverter. Disconnect the inverter
from the power supply. The beeping sound is a low battery warning,
indicating the voltage of the battery power supply is getting low. Please
restart the vehicle engine and charge the batter y before operating it with
the power inverter again.

TIPS

Measuring the AC Voltage

The output waveform of the AC inverter is a modified sine wave. To measure the
AC output voltage you must use a true RMS voltmeter.