Item no. 2464
Article no 2464
User’s Manual
Guide d’Utilisation
Power Dome LT
™
R
3
User’s Manual—Please read before using this equipment.
© 2008 Wagan Corporation.
All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
Thank you for purchasing the Power Dome LT by Wagan Tech. This product has been carefully engineered and manufactured to give you dependable operation. Please read this manual
thoroughly before operating your new product as it contains the information you need to
become familiar with its features and obtain the performance that will bring you continued
enjoyment for many years. Please keep this manual on file for future reference.
Features
Vehicle Battery Jumper
260 PSI Air Compressor
200 Watt Power Inverter
12 Volt Power Station
LED Work Light
USB Socket
Important
Prior to use, read and understand all warnings, cautions and instructions included
in this instruction manual, and those published by your vehicle battery manufacturer
and manufacturer of any device intended to be used with this unit. Retain these
instructions for future reference.
Please turn the master on/off safety switch (at the back of the unit) to the on position to operate this unit.
Work Light
Turn the Master on/off safety switch to the ON position.
Turn the work light switch (on front panel) to the ON position
The 3 LEDs will illuminate.
Turn off while not in use.
Battery Status
Turn the Master on/off safety switch to the ON position.
The Power Gauge will show the battery level.
13–15 Volts: Ready to use.
12 Volt: Charge necessary
Below 12 Volt: Charge immediately
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Power Dome LT by Wagan Tech
4
Charging The Power Dome LT At Home With AC Power
Completely charge your Jumpstart before using for the first time.
Before recharging from an AC outlet, be sure the source voltage is correct. (i.e.110
volts or 230 volts)
Use only the chargers provided with unit.
Keep the Master on/off safety switch in the OFF position while charging.
Plug the AC charging cord into any standard wall outlet and the other end into the
AC/DC charging jack.
Full charge takes approximately 26–28 hours
Do not exceed recommended charging time 30 hours
Charging The Power Dome LT In Your Vehicle With DC Power
Keep the Master on/off safety switch in the OFF position while charging.
Plug the DC charging cord into any 12 volt (cigarette lighter) outlet and the other
end into the AC/DC charging jack.
Full charge takes approximately 6–8 hours
Do not exceed recommended charging time — initial charge 10 hours
Using The Air Compressor
Open the compartment door on the side of the Power Dome LT and pull out the air
hose.
Make sure nozzle lever is in the UP position.
Attach the valve adapter to the valve stem of the tire or other inflatable and push
the valve adapter lever down to lock into place.
Turn the Master on/off safety switch to the ON position.
Toggle the compressor switch on the front panel to the ON position.
Monitor the pressure gauge while inflating.
When appropriate pressure has been reached, turn the compressor off and discon-
nect the hose.
Using The 12 Volt DC Power Port
Remove the protective cover to one of the two DC 12V Socket plugs.
Plug in your 12 Volt accessory.
Turn the Master on/off safety switch to the ON position.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
R
www.wagan.com
5
User’s Manual—Please read before using this equipment.
© 2008 Wagan Corporation.
All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
Using The 110 Volt 200 Watt AC Inverter
Prior to connecting inverter, maker sure the inverter’s switch is in OFF position.
Prior to plugging in your device, make sure the device is off and ensure the current
draw of the device is below the maximum of 200 Watts.
Connect the electrical plug of the device to the AC Receptacle.
Turn the Master on/off safety switch to the ON position.
Press the Inverter Switch to “II” position, selecting USB+INVERTER.
Now turn on the device.
If the device does not activate, the inverter may have been over loaded or the input
voltage may be too low. See the Troubleshooting section for details.
Using The USB Socket
NOTE: Prior to connecting the accessory, make sure that the Inverter Switch is in the
OFF position.
Connect the USB interface cable of the accessory to the USB slot on the Power
Dome LT.
Turn the Master on/off safety switch to the ON position.
Press the Inverter Switch to “I” position, selecting USB to turn on the accessory.
You may operate the USB and the Inverter at the same time by turning the switch to
the “II” position or just operate the USB only with the “I” position
Caution
Some rechargeable devices are equipped with a separate charger, which can be
connected into this inverter AC receptacle. However certain rechargeable devices
are manufactured with built-in chargers (see device owner’s manual). This category
of devices may cause internal damage to inverters and should not be used with this
inverter. The temperature of the device must be monitored for the first 15 minutes of
operation. Abnormally elevated temperature of the device is an indication that they
should not be used with this inverter.
Jumpstarting Vehicles
Turn the vehicle ignition off. Turn off all accessories such as lights, radio, air conditioner, etc...
Make sure all switches on the Power Dome LT are turned off.
Securely connect the Red (+) clamp to your vehicle battery’s positive (+) battery
terminal.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Power Dome LT by Wagan Tech
6
Do not connect to the negative terminal. Connect the black (-) clamp to a non-moving metal part of the vehicle.
Turn the Master on/off safety switch to the ON position.
Start the vehicle. If the vehicle does not start, wait 3 minutes before trying again
(failure to wait may damage the Power Dome LT).
After the vehicle starts, disconnect the black negative clamp first before the red
positive clamp.
Specifications
Battery 12 Volt 12 Amp Rechargeable Sealed Lead Acid Battery
Work Light 3 x LEDs
Compressor 260 PSI Reading Gauge
Inverter 110 volt AC 200 Watt
12V DC Socket 12 volt 10A max.
USB Port 5 volt 500mA max.
Charging Time 26-28 hours by AC charger at home 6–8 hours by DC charger in
vehicle when engine is running.
•
•
•
•
R
www.wagan.com
Loading...