Item #2206
User’s Manual
SHEMO080100244TXC
www.wagan.com
2
Elite 3000W—Pure Sine Inverter by Wagan Tech
©2010 Wagan Corporation
All Rights Reserved
Wagan and wa gan.com are trademarks used by Wagan Corp oration
3
User’s Manual—Read before using this equipment
Introduction
Thank you for purchasing this Wagan Pure Sine Wave DC to AC Power
Inverter. It delivers a true sine wave AC identical to that of commercial power.
Use this inverter to power AC appliances in your vehicle, at a campsite, or
at home as an emergency source of AC power. Pure Sine Wave AC means
that your sensitive electronics such as audio/video systems, computers, and
communications equipment will operate properly. This inverter is powered from
12 volts DC and it will continuously deliver 3,000 watts AC power at 120
Volts, 60 Hz.
For your convenience, this inverter is supplied with a wireless remote control
and a set of cables. The installer must install a fuse and fuse holder for battery
protection. See Configuring Battery Bank section.
This Wagan 3,000 watt Pure Sine Wave Inverter is an indispensable addition
to your compliment of mobile power equipment. With minimal care and
proper treatment it will provide years of reliable service.
Read and understand this manual before installing and operating this inverter.
Keep this manual for future use.
About This Inverter.
This power inverter converts 12 volts, direct current (12V DC) to 120
volts alternating household current (120V AC). It easily powers TV/VCR
combinations, small microwave ovens, and refrigerators. It also operates at
high efficiency (up to 90%) that results in long running time and extended
battery life compared to other inverters with this level of power output.
This inverter has the highest surge capability in its class. Superior surge
capability of 6,000 watts allows the inverter to start most difficult motorized
appliances. Advanced microprocessor-controlled circuits run cooler and are
more reliable than competing units.
General Instructions:
• Keep the inverter away from any direct heat source or combustible
materials.
• Keep well ventilated–this device generates heat.
• Keep the inverter away from combustible gases.
• Do not continuously operate any equipment over 3,000 watts.
• This inverter is designed to operate from a 12 volt DC power source
only.
• Do not attempt to connect the inverter to any other power source,
including any AC power source.
• Incorrect battery polarity will damage the inverter and void the warranty.
• Keep this inverter in a dry environment.
• Do not open the inverter; there are no user serviceable parts inside.
SAFETY WARNING!
The i nverTer ouT puT can be leThal. imprope r use of T his inverTer may
resu lT in pro perT y damage, pe rson al inj ury, or loss of lif e.
Product Features
Front Panel
The Front Panel view shows the inverters ON/OFF Switch, Indicators, AC
Outlets, and Ground Terminal.
• ON/OFF Switch
This switch controls AC output of the inverter.
• Operating LED (Green)
When this green LED is lit, the inverter is operating normally.
• The FAULT indicator turns RED as the inverter shuts down because of:
Excessive Temperature, Overload, Under Voltage, or Over voltage.
Immediately turn off all AC appliances if the FAULT LED is lit. Allow the
inverter to cool before continuing. Make sure that the ventilation vents
are not blocked.
If an inverter “shutdown” was preceded by a buzzing sound, there may
excessive load, in combination with a low voltage or cable problem.
Observe the Digital Display for low battery voltage. Normal operating
range is 10.5V to 15V DC.
www.wagan.com
4
Elite 3000W—Pure Sine Inverter by Wagan Tech
©2010 Wagan Corporation
All Rights Reserved
Wagan and wa gan.com are trademarks used by Wagan Corp oration
5
User’s Manual—Read before using this equipment
• Digital Display
The Digital Display Shows the DC Voltage input that the inverter senses
at its terminals. Low battery, excessive load for the cables can cause
a low voltage reading and inverter shutdown. Low battery is also
indicated when the Audible Alarm sounds. An alternative display shows
the “Percent of Load that the inverter can handle”. If the inverter has
excessive load “OVL” will be displayed.
• AC Outlets
Each of the four outlets is rated at 15 Amps 115V AC maximum (1850
Watts). Use High Output Terminals for appliance loads greater than
1850 watts or for distributed wiring.
• High Wattage Output Terminals
There are three insulated terminals on the front panel of the inverter.
These terminals are for connecting 115 Volt AC devices that require more
than 15 amps to operate or for connection to distribution wiring with
multiple branches and AC outlets. Any AC output wiring that is directly
connected must comply with US National Electric Code (NEC) wiring
gauge recommendations. Facing the Front Panel, the terminals are:
Neutral and Ground are bonded (connected) inside the inverter to
comply with the NEC requirement that any AC source must have a
Neutral to Ground connection.
• Ground Terminal
The Ground Terminal is located on the Front Panel. This terminal is for
attaching a 6 gauge insulated safety ground wire. This safety wire
protects personnel if there is an unlikely failure in either the cabling or
enclosure insulation. Do not directly connect this ground to any Negative
DC inverter terminal. This safety wire is to be connected to the vehicle
frame or earth ground or negative battery terminal as described in the
installation procedure.
• Audible Alarm (internal to the inverter)
When the audible Alarm makes a buzzing sound, the inverter senses a
low battery condition. The user should reduce the AC load, charge the
battery, and check the DC cables for excessive losses.
Left Middle Right
Ground Neutral Hot (or Live)
Ground Terminal
Four 115V AC Outlets
Operating LED (Green)
Fault indicator (Red)
High Wattage Output Terminals
Digital Display
ON/OFF Switch
www.wagan.com
6
Elite 3000W—Pure Sine Inverter by Wagan Tech
©2010 Wagan Corporation
All Rights Reserved
Wagan and wa gan.com are trademarks used by Wagan Corp oration
7
User’s Manual—Read before using this equipment
Rear Panel
• Positive Terminal: Positive DC Input
• Negative Terminal: Negative DC Input
• Cooling Fans: High-speed and temperature controlled
Remote On/OFF Switch
This inverter is supplied with a 100-foot range battery-powered wireless remote
ON/OFF feature. To enable the Remote Switch, the front panel On/Off Switch
must be in the On position.
To turn On the inverter, momentarily press ON. To turn the inverter Off,
momentarily press “Lock”. If the wireless remote fails to control operation of
the inverter, you may be out of range for the radio signal—move closer to
the inverter. If the Remote Switch has a depleted battery, open the unit by
unscrewing the three small screws on the back side of the remote control and
replace the 12 volt model 23A alkaline battery with a new one.
Cooling Fans
Positive Terminal (+)
Negative Terminal (-)
ON switch
OFF switch
Sliding Cap
Retractable
Antenna
Retracted Antenna Extended Antenna
Loading...