Item No. / Artículo No 2741
User ’s Manual
Manual de Usuario
Brite-Nite
™
MEGA SPOTLIG HT
Carrying Handle
Emergency Beacon LED
AC Charger
DC Charger
* product may vary in appearance slightly from shown
Shoulder Strap
AC/DC Charger Input
Battery Status Indicator
Swivel Folding Stand
Latch Buckle
(for back cover)
Emergency Beacon
Power Switch
Halogen Bulb
Power Switch
H4 Halogen Bulb
Shoulder Strap Attachment
Brite-Nite™ Mega Spotlight™ by Wagan Tech
®
1
www.wagan.com
User’s Manual—Read before using this equipment
2
©2013 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
Thank you for purchasing the Brite-Nite™ Mega Spotlight™ by Wagan Tech®. With minimal
care and proper treatment, it will provide years of reliable service. Please read all operating
instructions carefully before using the unit. Keep this user’s manual for future reference.
INTRODUCTION
This spotlight is useful for accomplishing a variety of activities. In the field, it serves as a
powerful spotlight. During tire changes at night, the lantern can light the area while the red
flashing emergency beacon warns motorists to avoid the area. Two chargers are included
allowing either DC charge from a cigarette lighter socket or from any AC socket. The spotlight
has a folding stand that can be used to aim the spotlight beam onto a targeted area.
FEATURES
• Sealed rechargeable 12V lead-acid battery
• Charge in vehicle from cigarette lighter socket with 12V DC adaptor
• Charge at home with AC adaptor
• Large handle for easy carrying and use
• Red flashing emergency beacon LED light
• Yellow LED indicator lights let the user know that charging power is connected
• A retractable stand allows the spotlight beam to be positioned at a variety of angles
• Nylon shoulder strap for easy carrying
SPECIFICATIONS
• Operating Voltage: 12V DC
• Sealed Lead-acid Battery: 12V DC, 7 AH
• Quartz Halogen Bulb: 12V, 50/120 Watt, H4
• Dimensions: 40 × 25.5 × 26.3 cm
• Weight: 4.4 kg
GENERAL SAFETY PRECAUTIONS
Failure to heed these precautions may result in personal injury and/or property damage.
• As with all lead-acid cell batteries, be sure to fully recharge the battery before storing.
• Turn off all lamp functions and allow unit to cool before storing.
• Do not drop unit as this may cause damage.
• The lens will become hot during operation even after immediate shutdown of unit.
• Do not cover lens or reflector during operation.
• Do not shine lights directly into eyes.
• When maintaining the spotlight, always wear safety glasses.
Brite-Nite™ Mega Spotlight™ by Wagan Tech
®
3
www.wagan.com
• Only use supplied chargers.
• Recharge fully every 3–6 months even if the unit is not in use. This will prolong the life
of the battery.
• This power unit is intended to be correctly orientated in a vertical or floor mount
position. Do not lay the spotlight lens downward when on.
• Do not use in wet conditions for the spotlight may short circuit.
• Do not expose to high temperature or fire, as the battery may explode.
• Charging produces hydrogen gas that may explode when exposed to fire.
• Do not use near flammable liquids, combustible materials or gasses.
• Do not use for any other purpose than momentary lighting.
• Do not modify or alter this unit.
• Do not charge the spotlight for more than 30 hours. Overcharging will shorten battery
life.
• Avoid charging the battery at temperatures below 4°C.
• The DC/DC Charger cigarette lighter plug becomes warm when used. Unplug from
cigarette lighter receptacle with caution.
• Keep out of reach of children.
CHARGING YOUR SPOTLIGHT
Your Mega Spotlight™ is supplied with two charging adapters. One adapter is powered by
standard 240 volts AC. This is the AC/DC charging Adapter. The other charging adapter is
the DC/DC charging adapter. Be sure to charge the unit completely before the first use. This
step will prolong the life of the internal battery. Use the AC/DC charging adapter for the first
charge. Charge the battery for 24 hour before first use. DO NOT use any charging means other
than those provided. DO NOT operate the spotlight while charging, as you may damage the
charging adapter and discharge the spotlight’s batteries.
AC Charging
The AC/DC adapter provides a slow steady charge to the unit. Charge for a maximum of 16
hours (except for the initial 24 hour charge) and do not overcharge.
1. Make sure that all switches are set to “O”, the off position
2. With the AC/DC Adapter, insert the DC plug into the AC charger jack on the spotlight
3. Plug the wall module of the AC/DC adaptor into the AC outlet on wall
4. The red indicator LED will light up to indicate the spotlight is charging
5. Indicator LEDs will illuminate increasingly, from RED, YELLOW to GREEN depending
on battery status at time of charging.
• RED LED: Battery is low
• RED/YELLOW LEDs: Battery is slightly full
• RED/YELLOW/GREEN LEDs: Battery is medium full
• RED/YELLOW/2 GREEN LEDs: Battery is completely full
User’s Manual—Read before using this equipment
4
©2013 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
DC Charging
Any 12V DC power outlets, such as ones found in automobiles, boats and jump starters can
charge this spotlight using the DC/DC charging adapter. For full charge, the power source must
be from a vehicle or boat DC outlet and the engine should be running. Charge for 10 hours
maximum. Do not overcharge.
1. Make sure that all switches are set to “O”, the off position
2. With the DC/DC adapter, insert the smaller DC plug into the DC charger jack on the
spotlight
3. Plug the larger DC plug into the cigarette lighter outlet
4. The Indicator RED LED will light up to indicate the spotlight is charging
5. Indicator RED/YELLOW LEDs will illuminate during charging.
USING THE HALOGEN SPOTLIGHT/FLASHING EMERGENCY LIGHT
There are two Rocker type switches. One switch has 2 positions, the other has three positions
and are marked I, 0, and II. Always store the lamp with both switches in the “O” position.
The halogen spotlight rocker switch and functions are shown in the table below:
Switch Location/Function Halogen Spotlight (Rocker Switch 1)
“O” Position OFF
“I” Position Spotlight ON — High intensity
“II” Position Spotlight ON — Low intensity
The flashing emergency light rocker switch and functions are shown in the table below:
Switch Location/Function Flashing Emergency Light (Rocker Switch 2)
“O” Position OFF
“I” Position Flashing Red Emergency LED ON
USING THE SWIVEL FOLDING STAND
To adjust the stand, loosen all lock caps by turning the caps counter-clockwise. Position the
stand to desired height and angle. Once at desired position, tighten the caps by turning
clockwise until the stand is securely fixed.
USING THE BATTERY STATUS INDICATOR
Make sure all switches are set to the “O” OFF position. Unplug all chargers from the spotlight.
Press the TEST button to indicate battery status.
• RED LED: Battery is low. Charge immediately.
• RED/YELLOW LEDs: Battery is partially full.
• RED/YELLOW/GREEN LEDs (all LEDs ON): Battery is fully charged.
Brite-Nite™ Mega Spotlight™ by Wagan Tech
®
5
www.wagan.com
USING THE SHOULDER STRAP
Locate the shoulder strap holes at the front and rear at the base of the handle. Obtain the nylon
shoulder strap. Open the clip at one end of the strap and hook onto one of the shoulder strap
holes. Open the clip at the other end of the shoulder strap and hook onto the other shoulder
strap hole.
REPLACING THE SPOTLIGHT BULB (Fig.1)
The Mega Spotlight™ uses a 12V, 50/120 Watt H4 quartz-halogen bulb. If the spotlight bulb
burns out, you can purchase a replacement from most automotive supply stores.
Procedure
1. Make sure ALL charging adapters are disconnected from the unit.
2. Make sure ALL switches are set to the OFF “O” position.
3. Make sure spotlight is cool. Allow at least 30 minutes after service before handling
bulb.
4. Pull off the front rubber edging.
5. Unscrew (8 screws) the spotlight cover and remove.
6. Gently remove the lens and rubber ring.
7. Carefully remove the reflector assembly.
8. Release the bulb guarding wire from the reflector flange, freeing the bulb from the
reflector housing.
9. Disconnect the colored wires from the bulb wire terminals, making sure to note for
proper reattachment later which colored wire was connected to their respective bulb
wire terminal.
10. Carefully remove the bulb and set it aside.
NOTE: The glass of the new bulb must not be touched with bare hands. Finger grease
deposited on the glass will create hot spots on the bulb and decrease its life. If the
bulb glass is accidentally touched, it can be cleaned with a lint free cloth dampened
with alcohol.
11. Carefully remove the new bulb from its package without touching the bulb’s glass.
12. Place the new bulb in the reflector assembly flange.
13. Replace the wire guarding the bulb, hooking the ends into the reflector flange.
14. Connect colored wires onto their respective bulb wire terminals.
15. Replace the reflector assembly, rubber ring, and lens.
16. Screw on the spotlight cover making sure it is secure.
17. Pull the rubber edging around the spotlight cover.
18. Check for proper operation by turning ON the switch.
19. Recharge the battery as required.
Lens
Front Rubber Cover
Spotlight Cover
8 x Screws
8 x Screws
Rubber Ring
Wire for Guarding Bulb
H4 Halogen Bulb
3 x Wire Terminals
User’s Manual—Read before using this equipment
6
©2013 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
(Fig.1)
Brite-Nite™ Mega Spotlight™ by Wagan Tech
®
7
www.wagan.com
REPLACING THE BATTERY (Fig.2)
WARNING: This battery contains lead. Exposure to lead is known to cause birth defects, other
reproductive harm and cancer.
Pb
Let competent personnel replace and dispose of the battery. DO NOT
reverse the polarity when connecting battery. The battery in the Spotlight
is a 12V, 7AH sealed lead-acid battery. Factors regarding the state of
charge, vibrations and temperature can decrease battery life. When
disposing of lead-acid batteries, follow local regulations. Batteries contain
substances that can have potential environmental and health effects.
Contact your local Solid Waste Authority for recycling information.
1. Unscrew and remove the rear cover locking screws.
2. Take off the locking buckles.
3. Remove the back cover and set aside.
4. Pull out the battery.
5. Disconnect the terminals from the wiring and set aside the battery in a safe area.
6. Obtain the new battery and connect the wires to the battery terminals. Black wire to
the negative (−) lead. Red wire to the positive (+) lead.
7. Place the battery back into the spotlight housing.
8. Put the rear cover over the end of the spotlight housing.
9. Replace the locking buckles.
10. Screw the rear cover locking screws securely into the spotlight housing.
DISPOSAL/RECYCLING
All electronic equipment contains materials that can damage the environment if not properly
disposed of. Contact your local authority for disposal or recycling instructions.
If the batteries are disposed of incorrectly, the toxic contents can potentially leak into the
ground and/or the water supply. It is important that consumers who have access to the used
batteries dispose of them properly. Please recycle the battery at your local recycling centers or
household recycling centers in your community.
WARNING: This battery contains lead. Exposure to lead is known to cause birth defects, other
reproductive harm and cancer.
Pb
This symbol means the rechargeable battery contains lead, Pb, and must
be disposed of or recycled properly according to local regulations.
Loading...