Cordless Spotlight Compressor
By Wagan Tech
www.wagan.com
2
Item no. 2450
Thank you for purchasing the CORDLESS SPOTLIGHT COMPRESSOR by
Wagan Tech. With normal care and proper treatment it will provide years of
reliable service. Please read all operating instructions carefully before use.
FEATURES:
• Use as a power source for audio/video accessories, cell phones, camping
accessories and more
• Recharge and start an auto battery in minutes
• Super –bright adjustable-angle flashlight
• 260 PSI high power air compressor
• 3 LED reading light
• Accurate air compressor gauge
IMPORTANT NOTES:
• Before attempting to start vehicle, this unit must be removed from the
vehicle’s 12V socket. See “CHARGING A DEAD BATTERY” section
for details.
• WAGAN 2450 comes fully charged. However, you should initially
charge the unit before use. See “CHARGING WAGAN 2450” section for
details.
• The unit is designed to recharge 12V batteries with a low voltage between
10.4 and 10.5 volts. If vehicle battery is severely drained, call a service
center or tow truck.
• CAR ALARMS: If you have a car alarm, put it into “valet mode” before
attempting to use. Many popular car alarm models cut off the power to
the vehicle’s electrical system. It will not work while this type of alarm is
engaged.
• For optimum performance, store in temperatures between 32°F-110°F
(0°C-43°C). Temperatures below 45°F (7°C) and above 85°F (30°C) will
require at least an additional 10 minutes of recharging before starting
engine.
• During operation, the unit may feel warm. Discontinue use if it becomes
too hot.
• Do not attempt to reverse polarity. 25A fuses are used in a protection
system which regulates the discharge and recharge of this unit.
User’s Manual
USER’S MANUAL — Please read before using this equipment.
© 2007 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
3
Cordless Spotlight Compressor
By Wagan Tech
WARNING: KEEP OUT OF REACH OF CHILDREN.
READ ALL INSTRUCTIONS BEFORE
USE.
DANGER SHOCK HAZARD. Keep battery charger and adapter away from
wat
er and other liquids. Never operate if cord is damaged or product is not
working properly. Unplug when not in use.
WARRANTY: Th
e products are designed with quality in mind. This product is
warranted against defects in material and workmanship for one year from date of
purchase. This warranty does not apply to defects or damage caused by m isuse,
alteration, or normal wear and tear, and is limited only to replacement of this
tool.
CHARGING AN EMPTY BATTERY
Note: Before attempting to start vehicle,
this unit must be removed from
the vehicle’s 12V socket.
• Turn
off all lights and all other accessories (radio, etc) in the vehicle.
Tip: keep one small vehicle light or dial turned on to aid in determining
if th
e battery is charging.
• Make s
ure the vehicle’s 12V Socket is clean and free of debris.
• Pu
t the end of the Male-to-Male 12V Car Power Card with no LED
light into Wagan 2450 12V socket.
• Pu
t the lighted end of the Male-to-Male Car Power Cord into the
vehicle’s 12V socket
• Pu
sh the Master Switch to the OUTPUT position.
• Th
e Indicator Light on the 12V connector will illuminate, and the light
or dial left on in the vehicle should brighten. If the light or dial does not
brighten, turn the ignition key ONLY as far as the accessory position
(see vehicle owner’s manual.) In some vehicles, this is necessary for
the 12V socket to operate.
• If t
he light or dial still does not brighten, turn off the light or dial, and
allow this unit to remain on the 12V socket for at least 35 minutes.
Remove it from the 12V and attempt to start the vehicle.
• If
the vehicle does not start, DO NOT attempt to start the engine
more that twice. Call a service center or tow truck.
www.wagan.com
4
USING AS A DC 12V POWER SOURCE
• Waga
n 2450’s 12V DC Power Socket mimics the 12V socket of a
vehicle.
• Any
accessory you would normally plug into your vehicle’s 12V socket
(cell phone, camcorder, flashlight, radio, etc.) can be powered from
Wagan 2450’s 12V socket, using Wagan 2450’s built-in battery as the
power source.
• Th
is unit’s 12V DC socket is center pin positive (+). Most 12V DC
accessories come with this configuration, but not all. Before connecting
any accessory to Wagan 2450 12V socket, check the accessory
owner’s manual for the polarity of the accessory.
• If t
he accessory is center pin positive, simply plug it into the 12V socket
push the master switch to the OUTPUT position and run normally.
• Fo
r the DC accessories that ate NOT center pin positive, you must use a
DC to DC adapter (not included.)
RECHARGING
RECHARGING FROM A 12V DC SOURCE (Car, Truck, Boat, 12V DC
char
ger)
Simply leave Wagan 2450 plugged into a 12V DC power source for 8-10 hours.
As
with any 12V Lead Acid Battery (car batteries), charging the unit periodically
is permitted as Lead Acid Batteries do not have memory.
RECHARGING FROM AC POWER SOURCE
An AC Power Adapter is included for recharging from a standard power outlet.
Si
mply leave this unit plugged into a power outlet for 25-27 hours to fully charge.
Do not leave this unit plugged into the 12V s
ocket when the vehicle is not running
as it may drain power from the car battery. When charging in a vehicle, leave the
engine running or charge while driving.
Loading...