Installing and connecting the refrigerator COOLMATIC CR Series
38
7.2 Undo the lock
The refrigerator has a locking mechanism (fig. 8 1, page 6) which is also
used, to protect it during transport. The following settings are possible:
z Lock (turn wheel clockwise to the end stop): The door is locked and
secured.
To open the door, lift the handle up and open it.
z Vent (turn wheel anti-clockwise to the end stop): The door is slightly open,
but fixed in position.
Use this position, if you are not going to use the appliance for a long time.
7.3 Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in fig. a, page 8 to fig. c, page 8, to change the
hinges.
7.4 Connecting the refrigerator
Connect the refrigerator to DC power
The refrigerators CR-50, CR-65, CR-80 and CR-110 can be operated with
12 V or with 24 V DC.
Caution
To avoid voltage drops and loss of performance, keep the cable as
short as possible and avoid joins.
For this reason avoid additional switches, plugs or multi-way
adapters.
➤ Determine the required cross section of the cable in relation to the cable
length according to fig. d, page 9.
Key for fig. d, page 9
Caution
Make sure that the polarity is correct.
Co-ordinate axis Explanation Unit
l Cable length m
∅ Cable cross section mm²
_cr-kuehlschraenke.book Seite 38 Montag, 13. Februar 2006 3:46 15