Assembly Instruction
ToolsRequired:
LightSource:
Flatheadscrewdriver,Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
IntegratedLED22W
CompatibleDimmerSwitches:LutronDVELV-300Por Lutron SELV-300P.
EstimatedAssembly Time:
Preparation:
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
20-30minutes
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Package Contents
2.4mm
13Ga13Ga
G
ND
Crossbar
A
x1
Mounting Screw
B
x2
C
Fixture Body
x1
STEP 1 - Adjust Lamp Tube
A. By holding the metal part of the lamp tube, carefully rotate lamp
tubes anti-clockwise to your desired directions.
Note: The shortest lamp tube against the ceiling canopy is the fixed
lamp tube, which cannot be rotated.
STEP 2 Attach Crossbar to Outlet
Box
A. Attach the Crossbar (A) to Outlet
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
B. Use standard wire connectors (not included) to make all wire
-
Outlet
Box
Box and secure by threading Outlet
Box Screws (not supplied) into the
Mounting Holes on the Outlet Box.
Tighten until snug.
A
Outlet Box
Screw
Figure 2
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
White wire
from outlet box
Black wire from
outlet box (or Red)
White wire
from fixture
Black wire
from fixture
Figure 1
Fixed Lamp Tube
(Shortest one against
the ceiling canopy)
FRONT VIEW
Fixed Lamp Tube
(Shortest one against
the ceiling canopy)
ROTATE
BOTTOM VIEW
ROTATE
STEP 4 - Attach Ceiling Canopy to Crossbar
A. Line up the holes on the side of the ceiling canopy to the mounting
holes on the Crossbar (A). Secure them with Mounting Screws (B).
Tighten until sung.
Your fixture is now assembled and ready to use. Enjoy!
Metal
ROTATE
ROTATE
Thank you for purchasinga product.
1of2
Bare, or Green
Ground wire
from outlet box
Green Ground Screw
on the Crossbar
B
Ground wire
from Fixture
Figure 3
A
Figure 4
Ceiling
Canopy
FINISH: POLISHED CHROME
2.4mm
13Ga13Ga
G
ND
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4"
7.75” Dia.
6” Dia.
8.5”
22.25” Dia.
Thank you for purchasinga product.
2of2
Loading...