Label Picture Description QTY
A
Side Panel
1
B
Back Support Bar
1
C
Seat Panel
(Labeled with 'face' and
'bottom')
1
D
Leg Support Bar
1
E
Seat Cushion
1
F
Back Cushion
2
Caution : You must read this before you proceed
Sofa Corner
1 OF 7
Label Picture Description QTY
①
Bolt (M6*20MM)
11
②
Allen Key
1
Before
Beginning
Assembly:
2 OF 7
Step 1
Overview
This Sofa Corner has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Sofa parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps before
assembly.
Open the carton and place all the parts onto a clean, non-marring surface.
Remove the plastic plugs( prevent the alum tube was scratched) in the four ends of the Seat
Board(C) using Allen Key(②) as shown above.
FRONT FACING
Leg Support Bar（D）
Side Panel（A）
Back Support Bar（B)
Seat Panel（C）
Seat Cushion（E）
Back Cushion（F）
3 OF 7
Step 2
Step 3
Place the Side Panel(A) with its inside facing up.
Insert the Seat Panel(C) into the Side Panel(A).
3.1) Attach the Seat Panel(C) to Side Panel(A) using Bolts(①) with Allen Key(②) as shown
above.
3.2) Attach the Seat Panel(C) to Side Panel(A) using Bolts(①) with Allen Key(②) as shown
above.
4 OF 7
Step 4
Step 5
Attach the Back Support Bar(B) to the Side Panel(A) using Bolt(①) with Allen Key(②).
Do not fully tigthen Bolts.
4.1) Remove the plastic plugs( prevent the alum tube was scratched) in the both ends of Back
Support Bar (B) using Allen Key(②) as shown above.
4.2) Insert the Back Support Bar(B) into the Side Panel(A).
5 OF 7
Step 6
Step 7
Insert the Leg Support Bar(D) into the Back Support Bar(B) and Seat Panel(C) as shown above.
7.1) Attach the Leg Support Bar(D) to Back Support Bar(B) and Seat Panel(C) using Bolts(①) with
Allen Key(②) as shown above.
7.2) Attach the Leg Support Bar(D) to Back Support Bar(B) using Bolts(①) with Allen Key(②) as
shown above.
Do not fully tigthen Bolts.
6 OF 7
Step 8
Step 9
Put Seat Cushion(E) and Back Cushions(F) on the Sofa and stick the velcro from back cushion to
seat cushion as shown above
Your Sofa Corner is ready for use.
Stand the Sofa Corner up.
Place the Sofa Corner on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully, sit onto the Sofa Corner.
This will help to align all the parts at all joints.
Then get off the Sofa Corner, and in a sequential manner, proceed to tighten all Bolts.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute the same process.
If the Sofa is not stable it could lead to damage to the product.
Note: This step is done best with the assistance of a second adult.
7 OF 7
Loading...