ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
WARNING:
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before
installation, discharge yourself by touching a grounded bare metal surface to remove this
hazard. To avoid damage, do not touch the LED module.
Hardware Package (included):
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Mounting Plate (A)
Ball Nut (F)
Outlet Box
Wire Connector (E)
House Grounding Wire
Fixture Grounding Wire
Green Grounding Screw (C)
Mounting Screw (B)
Rubber Pad (G)
Headless Screw (H)
Mounting Plate
Mounting Screw (B)
(A)
Lock Nut
(D)
Green Grounding
Screw (C)
Headless screw (H) Glass Holder (I)
Back Plate
Fixture Wire
Lock Nut (D)
Wire Connector (E)
Ball Nut-b (J)
Ball Nut (F)
Rubber Pad (G)
Glass
Installation Steps
Turn off the power at fuse or circuit box
1. Thread two headless screws (H) through the mounting plate (A), then secure them with
four lock nuts (D) ( two on each side of the mounting plate (A) ). Adjust the length of the
headless screws (H) if necessary ).
Note: Make sure that the headless screws (H) are lined up horizontally, to ensure that
the fixture will be level.
2. Attach the mounting plate (A) to the outlet box by using two mounting screws (B).
Glass Holder (I)
Ball Nut-b (J)
4. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections (E) using the
wire connectors (E):
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the cross bar with the green grounding screw (C). Then connect it to the
house grounding wire with a wire connector (E).
Carefully put the wires back into the outlet box.
5. Attach the fixture to the mounting plate (A) by inserting the headless screw (H), then secure it with two rubber pads (G)
and two ball nuts (F).
6. Attach the glass holder (I) to back plate, use ball nut-b (J) secure glass holder (I) to fix glass.
Turn on the power at fuse or circuit box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Plate (A)
Ball Nut (F)
A
Mounting Screw (B)
Rubber Pad (G)
Green Grounding
Screw (C)
Headless screw (H) Glass Holder (I)
Lock Nut (D)
C
Mounting Hardware
(1 SET)
Wire Connector (E)
Ball Nut-b (J)
Glass
A: 18"
B: 6-1/2"
C: 6-1/4"
B
Loading...