Assembly Instructions
Caution: You must read this before you proceed
Table
Parts List
Label Picture Description QTY
A Table Top 1
B Table Leg 4
Page 1 OF 7
Hardware
Label Picture Description QTY
① Bolt (M8x70mm) 9
② Spring Washer 9
③ Washer 9
④ Allen Key 1
Assembly Preparation
Before
Beginning
Assembly:
●
&
●
●
●
Read instructions, cover to cover-
Have 2 adults on hand for assembly-
Do not assemble on flooring or carpet-
Assembly on a clean non-marring surface (packing foam)-
●
Save all packaging until finished-
Page 2 OF 7
Assembly Steps
Overview
Table Top (A)
Table Leg (B)
Table Leg (B)
Table Leg (B)
Table Leg (B)
FrontFacing
This Table has multiple parts and may require up to 30 minutes to assemble. To give you
an overview of the Table parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to familiarise yourself with the parts
and steps before assembly.
Page 3 OF 7
Step 1
Unpack and place all parts on a clean, non-maring surface.
Step 2
B
Apron
Corner Block
3
2
1
4
B
B
B
A
With the assistance from your adult partner, place the Table Top(A) facedown on a clean,
non-marring surface.
Align Table Leg(B) against the corner of the Aprons and align the mounting positions.
Attach Table Leg(B) to Table Top(A) using Bolts(①), Spring Washers(②) and Washers(③)
with Allen Key(④).
Do not fully tighten the Bolts.
Repeat the same process with the three remaining Table Legs.
Page 4 OF 7
Step 3
If wobble
Test again
10CM~15CM
4
A
B
Place the Table on a Level Surface to see if it wobbles.
If it wobbles, with assistance from your aduly partner, lift the Table some 10cm to 15cm
high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Table freely and vertically with all four legs, hitting the ground, at the same time.
This Drop Test will help to ensure that all Bolts, and gaps reach full alignment status.
Test again for evenness on a Level Surface.
If no wobbles are found, proceed to tighten all the Bolts.
Note: When tightening the Bolts, tighten sequentially. Do not tighten any Bolt or fully
and then move towards the next one. This could cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same drop test.
Note: If the Table is not stable, it could lead to damage to the product.
Page 5 OF 7
Step 4
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Page 6 OF 7
Page 7 OF 7
Loading...