Wade Antenna Golden Nugget User Manual

DELHI TOWERS

Golden Nugget - Tubular Towers

Features

12”

(30.48 cm)

11 ¾”

(39.85 cm)

GN18T
GN16T

9’ 6”

(2.90 m)

10’

(3.05 m)

• Precision swaged legs for perfect fit.

• “Everdur” welded for high strength.

• Sleeve bearing for masts up to 1 ½”
(3.8 cm) diameter.

• Legs and braces “Galvanized” steel.

• Rotor plate for longer rotor life.

• Each section subjected to
pressure testing to ensure all
weld points pass the minimum
strength requirements. The
result is a safe and reliable tower

- look for dimple on braces.

Load Limits

Designed to support equipment up to 3 square ft. (0.28 m2) projected wind
area, mounted not more than 2 sections above house bracket.

Caution:

Guy wires must be used for larger loads or greater heights
above house bracket.

Sections

GN18T 18 gauge top section 9.6” (2.90 m).
GN18S 18 gauge straight section 10’0” (3.05 m).
GN16T 16 gauge top section 9’6” (2.90 m).
GN16S 16 gauge straight section 10’0” (3.05 m).

Note:

All sections complete with necessary nuts and bolts. Top sections
include top bearing set screw and lower mast clamp assembly.

Accessories

GNHB Universal house bracket 1” O.D. (2.54 cm) x 3’ (0.91 m) arms.
GNUHB Economical “U” house bracket.
GNBP 16 gauge base plate.
DMBS Galvanized steel drive stakes. Set of three.

1 ¼” (3.2 cm) x 3’ (0.91 m).

GN3HU 3’ hinge-up base.
CS-GN Climb Shield for GN Tower.
GS-GN Guy Station for GN Tower.

GNHB

GNUHB

12”

(30.48 cm)

DMBS

WADE ANTENNA’S ONGOING POLICY OF CONTINUING DEVELOPMENT MAY RESULT IN SPECIFICATION CHANGES TO ITS PRODUCTS

www.wadeantenna.com

GN18S
GN16S

GN3HU

NEW

GS-GN

GNBP

NEW

MADE IN CANADA

CS-GN

CAUTION NOTICE

Please read carefully

Our published installation guidelines are for standard towers and mounting devices as
specified. These guidelines are based on assumed soil conditions (190 KPA or 4000 PSF)
that may or may not exist in your area and on the assumption that no damage has occurred,
or modifications are made to the tower or mounting device.

A qualified structural engineer should be consulted prior to installing any tower or
supporting structure.

WARNING!

!

Survey your installation site NOW to prevent your antenna or support from coming in
contact with overhead powerlines. Caution should be used when climbing towers and
support structures.

FAILURE TO EXERCISE CAUTION MAY RESULT IN SERIOUS INJURY OR DEATH.

www.wadeantenna.com

MADE IN CANADA