Wacom Co DTU1031 Users manual
Contents
DTU-1031
1
Important Product Information
Precautions
Product Specifications
Disposal and Recycling Information
Regulatory Statement
License and Warranties
Contents
1
Contents
DTU-1031
Important Product Information
Version 0.# B0112
Copyright © Wacom Co., Ltd., 2013
All rights reserved. No part of this manual may be reproduced except for your express personal
use.
Wacom reserves the right to revise this publication without obligation to provide notification of
such changes.
Wacom does its best to provide current and accurate information in this manual. However,
Wacom reserves the right to change any specifications and product configurations at its
discretion, without prior notice and without obligation to include such changes in this manual.
2
The above year indicates when this manual was prepared. However, the date of release to the
users of the "manual" is simultaneous with the introduction into the market of the applicable
Wacom product.
Wacom is a registered trademark of Wacom Co., Ltd.
Contents
2
CONTENTS
Contents
3
Precautions 4
Precautions on use and handling 4
Physical location 4
Environment 4
Usage 5
Handling 6
Product Specifications 10
General Specifications 10
Display 11
Pen Tablet 12
Pen 12
Disposal and Recycling Information 13
EU RoHS 13
Turkey RoHS 13
EU disposal information (WEEE) 13
United States E-waste Program 13
Regulatory Statement 14
License and Warranties 16
Tablet driver software end user license
agreement
(Worldwide except for Europe, Africa and
Middle East) 16
Tablet driver software end user license
agreement
(Europe, Middle East and Africa) 21
Limited warranty
(U.S.A. and Canada) 26
Limited warranty
(Central America, South America and the
Caribbean) 28
Limited warranty
(Europe, Africa and Middle East) 30
FCC notice 14
Industry Canada (Canada only) 14
CE declaration 15
Contents
3
Contents
PRECAUTIONS
PRECAUTIONS ON USE AND HANDLING
To ensure the safe operation of the product, be sure to follow all instructions, cautions, and
warnings found within this manual. Failure to do so could cause damage to the product,
damage to your computer, or loss of data. Failure to do so could also void your warranty, in
which case Wacom shall have no responsibility to repair or replace the product.
PHYSICAL LOCATION
WARNING
The product should be used in normal office environments. It may be used also as a center
console in climate controlled environments. The product was tested by Wacom for usage in
a normal office environment only, and there was no testing for compatibility in medical and
military application areas.
The interactive pen display is neither waterproofed nor explosion resistant.
It serves and can be used solely as a passive display and input device.
In all applications that are not designated for its sole usage, no testing has been done on
the functionality and possible malfunctions of the interactive pen display. The adoption of
the interactive pen display in application areas other than normal office environments is at
the user’s risk.
4
ENVIRONMENT
CAUTION
Temperature and humidity
• Operating temperature and humidity: 5 °C to 35 °C, 20 % to 80 % RH
• Storage temperature and humidity: -10 °C to 60 °C, 20 % to 90 % RH
Do not use or store the product where:
• Temperature changes are severe or exceed specifications (e.g. outdoors or inside a
vehicle).
• The pen display, the pen, or the display stand are exposed to direct sunlight or heat
from an appliance, or are exposed to water or any other kind of liquid.
Do not use the product in a dusty environment; this may damage it.
Contents
4
Contents
USAGE
WARNING
Only use a power adapter specified for use with the product. If a different type of power
adapter is used, the product will not work properly or may be damaged. Using a different
type of power adapter also has the potential to result in fire. Use of a different power
adapter will void your warranty.
Regularly remove dust build-up from the power plug. The addition of moisture, etc., to
accumulated dust may create a fire hazard.
Do not damage, forcibly bend, or bundle the power cord. Do not place heavy objects on
the cord or expose it to excessive heat. Ignoring this warning may result in fire, electrical
shock, or product failure.
Do not connect or disconnect the power adapter with wet hands. Ignoring this warning
may result in electrical shock or product malfunction.
Do not insert a metal object or any foreign material into the USB port, video connector
ports, or any other opening on the product. Doing so may cause product malfunction, fire,
or electrical shock.
5
CAUTION
Provide adequate ventilation to the product. Poor ventilation may cause it to overheat or
malfunction, and shorten the life of the product.
When not using the product for long periods of time, unplug the power adapter from the AC
outlet.
To protect the health of your eyes when using the product:
• Use the product only in a well-lit room, and do not sit too close to the display screen.
• Take regular breaks when using the product for extended periods of time.
Contents
5
Contents
Take care of the LCD display. Do not push down forcibly with the pen on the LCD display.
Pushing down forcibly on the display may cause ripple-like striped patterns to temporarily
appear on the display. The ripples disappear when you stop pushing down with the pen.
The following conditions are characteristics of LCD displays and do not indicate damage or
malfunction to the product.
• Depending on the displayed contents, uneven brightness may be produced.
• Depending on the displayed contents, a small portion of lit and unlit lines, or red or blue
dots may be visible.
• When displaying objects with delicate patterns, flicker or striped patterns may be
produced.
• After displaying the same still image for an extended period of time, a residual image
may be produced. (Residual images will gradually disappear over time.)
• Changes to the condition of the back light over the period of using the display will
gradually affect the condition of the display.
• Depending on the angle from which the display is viewed, the colors and hues may
appear changed.
6
HANDLING
WARNING
High Voltage. Do not open or disassemble the product. There is a risk of electrical shock
when the casing is open. Opening the case will void your warranty and Wacom shall have
no responsibility to repair or replace the product.
Ensure that cabling or other objects do not get entangled in the moving parts of the stand.
Do not place the product on any wet surface or table. The rubber pads of the stand may
slip, allowing the product to fall.
When moving the product, ensure all cables are fully disconnected from the power
outlet, computer, and other areas. Appropriately bundle the cables to ensure they do
not hang free and create a hazard. Tripping over loose cables can cause physical
damage or personal injury.
Do not place the product on any unsteady surface or table. Do not place it on slanted
areas, unstable areas, or areas where vibration is present.
Physical damage or personal injury may result if the product falls from an unsuitable
surface.
Contents
6
Contents
Do not sit on, or hang from, the table or other surface where the product is placed. The
product may fall and cause physical damage or personal injury. Take extra care where
children are present.
If the LCD screen has been damaged, DO NOT touch any liquid that may be leaking from it;
this liquid is an irritant. In case of contact with skin, eyes, or mouth, rinse immediately with
running water for at least 15 minutes. If contact is made with the eyes or mouth, consult a
physician.
Choking hazard. Prevent children from swallowing the pen tip or side switch. The pen tip
or side switch may accidentally be pulled out if children are biting on them. Prevent children
from playing with any packing materials or wrapping, as a choking or suffocation hazard
may exist.
Refrain from using the product during thunder or electrical storms. Also disconnect the
product from the USB port of a computer during such weather. Using the product during
thunder or electrical storms may cause product malfunction, fire, or electrical shock.
7
Contents
7
Contents
CAUTION
Do not disassemble the pen. This may cause the device to malfunction. In this case,
Wacom shall have no responsibility to repair or replace the pen.
Do not strike hard objects with the pen, such as repeatedly tapping the pen against a desk
surface. Doing so may cause damage to the pen.
Do not apply excessive pressure or stress to the pen tip, cap, or side switch. This may
cause failure or malfunction.
Only use a replacement pen tip (nib) specified for the pen by Wacom.
Do not scratch the display screen. Avoid placing sharp objects on the display screen surface.
Avoid shock or vibration to the product, the display stand, and the pen. Hitting or dropping
the product may damage the display screen or other components.
Do not put heavy objects on the product or push against it with a strong force; this may
damage the display screen or break the display stand mechanism.
Do not place heavy articles on the cabling of the product, repeatedly bend the cables
sharply, or apply heavy stress to the cable connectors; this may damage the product or
cabling.
8
Do not store the product on a surface that would excessively bend or crimp the cable.
If your product has a coated surface, a worn pen nib that is sharp or angular may cause
damage. Replace the pen tip if necessary.
Do not use any organic solvent (e.g. alcohol) or even mild detergent to clean the display
screen. Use of these cleaners can damage the display screen. Damage of this kind is not
covered by the manufacturer's warranty.
• Before cleaning, always disconnect the product from the AC power source.
• To clean the display screen, use an anti-static cloth or a slightly damp cloth. When
cleaning, apply only a light amount of pressure to the display screen and do not make
the surface wet.
• To clean the pen display casing, the display stand, or the pen, use a soft cloth slightly
dampened with water.
Touching the same part of your body to the product (LCD panels and other areas) for
extended periods of time may cause low temperature burns. Avoid touching the product
with the same part of your body for extended periods of time.
Contents
8
Contents
Do not place metallic objects on the product when using the product. Doing so may cause
malfunction or damage to the product.
Placing other tablets or other devices near the product may affect the operation of the
product and cause malfunctions. If this happens, place the interfering devices to the side or
further away from the product.
To avoid permanently discoloring or altering the surface of your work area, periodically
move the product to another part of the surface.
Handle the display carefully. When lifting or moving the display, hold the product's main
body casing. Do not hold the display by the stand.
9
Contents
9
Contents
PRODUCT SPECIFICATIONS
GENERAL SPECIFICATIONS
Dimensions (W x H x D) 310 x 211 x 14 mm
Weight Main Body: 0.94 kg (TBD)
Power consumption 5 W max.
** W or less in sleep mode
Stand Integrated stand, 15 and 20 degrees from flat
Interface cables Special USB cable (Y-cable)
Cover plate AG etched glass (tempered glass)
Operating temperature & humidity 5 °C to 35 °C, humidity: 20 % to 80 %
(non-condensing)
Storage temperature & humidity -10 °C to 60 °C, humidity: 20 % to 90 %
(non-condensing)
(Maximum storage humidity is 38% at a
temperature of 60 °C, and maximum storage
temperature is 42 °C at a humidity of 90%.)
10
Contents
10
Loading...