Wacom Co DTH1620 User Manual

Wacom Cintiq Pro

Important Product Information

(DTH-1320/DTH-1620)

1

PRECAUTIONS

PRECAUTIONS ON USE AND HANDLING

To ensure the safe operation of the product, be sure to follow all instructions,
cautions, and warnings found within this guide. Failure to do so could cause
damage to the product , damage to your computer, or loss of data. Failure to do
so could also void your warranty, in which case Wacom shall have no
responsibility to repair or replace the product.

PHYSICAL LOCATION
WARNING

The product is solely for normal office environments but may be used also as
center consoles in climate controlled environments. The product was tested by
Wacom for the usage in a normal office environment only and there was no
particular inspection with regards to its compatibility in medical and military
application areas.

In addition, the interactive product is neither waterproofed nor explosion resistant.
It serves and can be used solely as a passive display and input device.
In all applications that are not designated for its sole usage, no information on the

functionality and possible malfunctions of the interactive product can be supplied
due to inadequate execution of tests. The adoption of the interactive product in
other application areas than normal office environments is at the user’s risk.

CAUTION

Temperature and humidity

• Operating temperature and humidity: 5°C to 35°C, 20% to 80% RH

• Storage temperature and humidity: -10°C to 60°C, 20% to 60% RH
Do not use or store the product where:

• Temperature changes are severe or exceed specifications (e.g. outdoors or
inside a vehicle).

• The product and, the pen, are exposed to direct sunlight or heat from an
appliance, or are exposed to water or any other kind of liquid.

Do not use the product in a dusty environment; this may damage it.

USAGE
WARNING

Only use a power adapter specified for use with the product. If a different type of
power adapter is used, the product will not work properly or may be damaged.
Using a different type of power adapter also has the potential to result in fire. Use
of a different power adapter will void your warranty.

Regularly remove dust build-up from the power plug. The addition of moisture,
etc., to accumulated dust may create a fire hazard.

Do not damage, forcibly bend, or bundle the power cord. Do not place heavy
objects on the cord or expose it to excessive heat. Ignoring this warning may
result in fire, electrical shock, or product failure.

Do not connect or disconnect the power adapter with wet hands. Ignoring this
warning may result in electrical shock or product malfunction.

Do not insert foreign material into the USB port, video connector ports, or any
other opening of the product. If a metal object or foreign material is inserted into a
port or other opening of the product, it may cause product malfunction, fire, or
electrical shock.

CAUTION

Do not connect or disconnect the cable or power cables while the product or your
computer is turned on; this may damage the display or computer video card. In
this case, Wacom shall have no responsibility to repair or replace the product.

The product is for use with HDMI. Using an inappropriate HDMI cable may
damage the product.

Set up the AC adaptor and the product in a well-ventilated place. If used in a
poorly ventilated place it may overheat and cause it to malfunction, decreasing
the product life cycle.

When not using the product for long periods of time, unplug the power adapter
from the AC outlet.

Take care of the following points to protect the health of your eyes when using the
product:

• When using the product, only use it in a well lit room and view the display from
a suitable distance.

• Take regular breaks when using the product for extended periods of time.

Take care of the following points in regards to the LCD display.
Do not push down forcibly with the pen on the LCD display. Pushing down

forcibly on the display may cause ripple like striped patterns to temporarily
appear on the display (the ripples disappear when you stop pushing down with
the pen). The following conditions are characteristics of LCD displays and do not
indicate damage or malfunction to the product.

• Depending on the displayed contents, uneven brightness may be produced.

• Depending on the displayed contents, a small portion of lit and unlit red or
blue dots may be visible.

• When displaying objects with delicate patterns, flicker or striped patterns may
be produced.

• After displaying the same still image for an extended period of time, a residual
image may be produced. (Residual images will gradually disappear over time.)

• Changes to the condition of the back light over the period of using the display
will gradually affect the condition of the display.

• Depending on the angle that from which the display is viewed, the colors and
hues may appear changed.

1

HANDLING
WARNING

High Voltage. Do not open or disassemble the product. There is a risk of electrical shock
when the casing is open. This will also void your warranty and Wacom shall have no
responsibility to repair or replace the product.

Do not place the product on any wet surface or table. The product may slip, allowing the
product to fall from the surface.

When moving the product, ensure all cables are fully disconnected from the power
outlet, computer, and other areas. Tripping over loose cables can cause physical
damage or personal injury.

Do not place the product on any unsteady surface or table. Do not place it on slanted
areas, unstable areas, or areas where vibration is present.Physical damage or personal
injury may result if the product falls from an unsuitable surface.

Do not sit on, or hang from, the table or other surface where the product is placed. The
product may fall and cause physical damage or personal injury. Take extra care where
children are present.

If the LCD screen has been damaged, DO NOT touch any liquid that may be leaking
from it; this liquid is an irritant. In case of contact with skin, eyes, or mouth, rinse
immediately with running water for at least 15 minutes. If contact is made with the eyes
or mouth, consult a physician.

Choking hazard. Prevent children from swallowing the pen tip or side switch. The pen tip
or side switch may accidentally be pulled out if children are biting on them. Prevent
children from playing with any packing materials or wrapping, as a choking or
suffocation hazard may exist.

Refrain from using the product during thunder or electrical storms. Disconnect the
product also from the AC power source during such weather. Using the product during
thunder or electrical storms may cause product malfunction, fire, or electrical shock.

Do not disassemble the pen. This may cause the device to malfunction. In this case,
Wacom shall have no responsibility to repair or replace the pen.

Do not strike hard objects with the pen, such as repeatedly tapping the pen against a
desk surface. Doing so may cause damage to the pen.

Do not apply excessive pressure or stress to the movable portion. This may cause
premature failure or malfunction.

Only use a replacement pen tip (nib) specified for the pen by Wacom.
This product has parts made of metal. If you show symptoms of metallic allergy during

use, stop using the product, and consult a doctor immediately.
Do not scratch the display screen. Avoid placing sharp objects on the display screen

surface.
Do not use the Felt nib. It may scratch the display screen.
Avoid intensive shock or vibration to the product, the product stand, or the pen. Hitting

or dropping the product may damage the display screen or other components.
Do not put heavy objects on the product or push against it with a strong force; this may

damage the display screen or break the product stand mechanism.
Do not place heavy articles on the product cabling, repeatedly bend the cables sharply,

or apply heavy stress to the cable connectors; this may damage the product or cabling.
Do not store the product on a surface that would excessively bend or crimp the cable.
If your product has a coated surface, a worn pen nib that is sharp or angular may cause

damage. Replace the pen tip if necessary.
Do not use any organic solvent (e.g. alcohol) or even mild detergent to clean the display

screen. Use of these cleaners can damage the display screen. Damage of this kind is not
covered by the manufacturer's warranty.

• Before cleaning, always disconnect the product from the AC power source.

• To clean the display screen, use an anti-static cloth or a slightly damp cloth. When
cleaning, apply only a light amount of pressure to the display screen and do not
make the surface wet.

• To clean the product casing, the product stand, or the pen, use a slightly dampened
(with water) soft cloth.

Always disconnect the product from the AC power source if the product appears to be
malfunctioning, has been damaged by a fall, or in some other manner.

Touching the same part of your body to the product (LCD panels and other areas) for
extended periods of time may cause low temperature burns. Avoid touching the product
with the same part of your body for extended periods of time.

Do not place metallic objects on the product when using the product. Doing so may
cause malfunction or damage to the product.

Placing other tablets or other devices near the product may affect the product's
operation and cause malfunctions. If this happens, place the interfering devices to the
side or further away from the product.

Move the product periodically to another place on your work surface to avoid
permanently discoloring or altering the appearance of the surface.

If you lift the product, hold the product with both hands.

2

2

PRODUCT SPECIFICATIONS

GENERAL SPECIFICATIONS

Dimensions (W x H x D) DTH-1320 : *** mm (excluding protruding portion), DTH-1620:***mm (excluding protruding portion)

Weight DTH-1320 :*** kg, DTH-1620:***kg

Operating temperature & humidity 5 to 35 degrees C, Humidity: 20% to 80% RH (non-condensing)

Storage temperature & humidity

Stand integlated stand

Interface Cables USB Type C

Cover plate AG etching cover glass direct bonding with LCM

Input voltage 20 VDC

Power Management VESA DPMS

Power Consumption (with AC adaptor)

USB HUB 3 USB Type C port

DISPLAY

Display Panel a-Si Active Matrix TFT LCD (IPS)

Screen Size DTH-1320 : 13.3inch (293.76 x 165.24 mm), DTH-1620 : 15.6inch (345.6 x 194.4 mm)

Aspect ratio '16:9

Number of pixels DTH-1320 ;1920 x 1080, DTH-1620 :3840 x 2160

Input Video Connector USB Type C

Input Video Signal Display port

Output Video Connector USB Type C

Output Video Signal Display port

Supported Resolution DTH-1320 :1920 *1080, DTH-1620 :3840 * 2160

White Luminace Uniformity DTH-1320 ;65 % (min.), DTH-1620 :62.5 % (min.)

Pixel Pitch DTH-1320 :0.153 (H) x 0.153 (V) mm, DTH-1620 :0.09 (H) x 0.0- (V) mm

Viewing Angles @ CR>10 (horizontal/vertical) DTH-1320 :160(80/80) / 160(80/80) (min.), DTH-1620 :178(89/89) / 178(89/89) (min.)

Display Colors 16,777,216 colors

Contrast Ratio 800:1 (typ.)

Luminance (maximum) 360 cd/m2 (typ.) (TBD)

Response Time (Tr + Tf) 30 ms (typ.)

OSD Manual Control

Plug and Play DDC 2B, DDC/CI

LCD quality

' -10 to 60 degree C, Humidity: 20% to 90% RH (non-condensing)
(Maximum storage humidity is 38% at a temperature of 60 degree C, and maximum storage

temperature is 42 degree C at a humidity of 90%.)

*** W (Full load)
1 W or less in sleep mode (USB connected) it is CE & E-star ver.6.0 regulation.

0.5 W or less in OFF mode it is CE regulation.

OSD is controlled by DDC/CI command from PC with special APP.
(Brightness, Contrast, Color Temperature(5000K, 6500K, 9300K, USER),
Scaling(Full/Aspect), Reset)

Each LCD panel is produced under very stringent quality standards. Production techniques cannot
guarantee an absolutely perfect TFT display. Wacom does not allow any pixel to be always white or
always black. A small number of pixels are allowed to show a wrong color for some parts of the color
spectrum. This does not mean the display is defective.

3

3

PEN TABLET

Reading Technology Electro-magnetic resonance technology

Active Area DTH-1320 :293.76 x 165.24 mm, DTH-1620 :345.6 x 194.4 mm

Resolution 0.005 mm/point (5080 lpi)

Accuracy

Reading Height 5 mm or more (Center)

Accuracy Assurance Height 0 mm from cover plate

Maximum Report Rate 170 points/sec

Pen Tilt Range 60 degrees (all pens)

Pressure levels 8192 levels

Communication Interface USB

Stylus Pen KP-504E

± 0.5mm (center), the edge area 1 (20mm wide from edge of display area) to be ± 2.0mm,
the edge area 2 (3mm wide from edge of dsplay area) to be ± 4.0mm

TOUCH SENSOR SPECIFICATIONS

Technology type Projected capacitive

Active Area DTH-1320 : 299.04 x 170.88 mm, DTH-1620 :351.72 x 200.29 mm

Resolution 0.025 mm/point

Coordinate Accuracy ± 1mm (Center)

Maximum Report Rate 100 point/sec

POWER ADAPTER

Input voltage 100 to 240 VAC, 50/60Hz

Output voltage 20V DC

4

4