WAC Lighting WAC7329, WAC7325 Installation & Assembly

INSTALLATION INSTRUCTION

Impulse LEDme® Track Luminaires

H-LED810, L-LED810, J-LED810

CAUTION

• For Use with WAC “J”, “J2”,”L”, & ”H” track systems. Fixture may also be used on other manufacturers’ brands of track. (Consult
factory for compatibility)

• Read all instructions before installing.

INSTALLATION ON TRACK:
Fixture Installation for J-LED810

1. Fixtures are designed for use on “J” series WAC Lighting track only. They may also be used on other manufacturers’
brands of track. (Consult factory for compatibility)
Note: The track has a groove running its length to indicate polarity, and the locking tab has a slant for easy installation.

2. Insert adapter into track slot and rotate it 90°, The “P” contact and low side of the locking tab should point
to the grooved side of the tack.

3. Make sure the locking tab seat properly in the track slot.

4. Reverse procedure to remove. Track heads may be positioned anywhere along the track.

FIXTURE INSTALLATION FOR LLED810

1. Fixtures are designed for use on “L” series WAC Lighting track only. They may also be used on other manufacturers’ brands of
track. (Consult factory for compatibility)
Note: The track has a ridge running its length to indicate polarity, and the locking tab has a slant for easy installation.

2. Insert adapter into track slot and rotate it 90, so that the low side of the locking tab faces the ridged side of the track.

3. Make sure the locking tabs seat properly in the track slot.

4. Reverse procedure to remove. Track heads may be positioned anywhere along the track.

WAC Lighting

www.waclighting.com
Phone [phone] • Fax [phone]

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014

Headquarters/Eastern Distribution Center

44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]

Western Distribution Center

1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]

INSTALLATION INSTRUCTION

Impulse LEDme® Track Luminaires

H-LED810, L-LED810, J-LED810

FIXTURE INSTALLATION FOR HLED810

1. Fixtures are designed for use on “H” series WAC Lighting track only. They may also be used on other manufacturers’ brands
of track. (Consult factory for compatibility)
Note: The track has a groove running its length to indicate polarity, and the locking tab has a slant for easy installation.

2. Insert adapter into track slot, the two contacts should be positioned so that when rotated it 90°, they will face the grooved
side of the track. (This is the side with two at copper wires running its length)

3. Make sure the locking tabs seat properly in the track slot.

4. Reverse procedure to remove. Track heads may be positioned anywhere along the track.

OPTIONAL ACCESSORIES:
LENS SPECIALTY LENSES MAY BE ORDERED SEPARATELY

REPLACING THE LENS

1. Squeeze the ends of the spring together and remove
spring and lens

2. Replace lens and snap spring back into position

FRAMING PROJECTOR AND BARN DOORS ORDERED SEPARATELY

INSTALLING FRAMING PROJECTOR OR BARN DOORS

These accessories are simply press-tted by hand into the front of the xture. Lens should be installed prior.

WAC Lighting

www.waclighting.com
Phone [phone] • Fax [phone]

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014

Headquarters/Eastern Distribution Center

44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]

Western Distribution Center

1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]