INSTALLATION INSTRUCTIONS: Low Voltage Track Luminaires - IMPULSE
Retain these instructions
for future service and adjustments
Models: JHT-896LHT-896HHT-896
CAUTION:
- For Use with WAC “J”, “J2”,”L”,&”H” track systems. Fixture may also be used on other manufacturers’
brands of track. (Consult factory for compatibility)
- To reduce the risk of a burn during re-lamping, remove from the track before re-lamping.
- Read all instructions before installing.
INSTALLATION ON TRACK:
Fixture Installation for JHT-896
1. Fixtures are designed for use on “J” series WAC Lighting track only. They may also be used on other
manufacturers’ brands of track. (Consult factory for compatibility)
Note: The track has a groove running its length to indicate polarity, and the locking tab has an arrow
indicating locking direction.
2. Insert adapter into track slot and rotate it 90°. The arrow should point to the grooved side of the tack.
3. Make sure the locking tab seats properly on the track slot.
4. Reverse procedure to remove. Track heads may be positioned anywhere along the track.
Fixture Installation for LHT-896
1. Fixtures are designed for use on “L” series WAC Lighting track only. They may also be used on other
manufacturers’ brands of track. (Consult factory for compatibility)
Note: The track has a ridge running its length to indicate polarity, and the locking tab has a slant for easy
installation.
2. Insert adapter into track slot and rotate it 90° so that the low side of the locking tab faces the ridged side of
the track.
3. Make sure the locking tabs seat properly in the track slot.
4. Reverse procedure to remove. Track heads may be positioned anywhere along the track.
615 South Street, Garden City, NY 11530
Tel: (516) 515-5000 Fax (516) 515-5050
www.waclighting.com
Fixture Installation for HHT-896
1. Fixtures are designed for use on “H” series WAC Lighting track only. They may also be used on other
manufacturers’ brands of track. (Consult factory for compatibility)
Note: The track has a groove running its length to indicate polarity, and the locking tab has contacts which
are inserted into this groove.
2. The two contacts should be positioned so that when rotated, they will face the grooved side of the track.
(This is the side with two flat copper wires running its length)
3. Insert adapter into track slot. Pull downward on the adapter while rotating the adapter 90º.
4. Release the adapter so the locking tab sits in the track slot.
5. Reverse procedure to remove. Track heads may be positioned anywhere along the track.
RELAMPING:
:
1. Turn the power off at the main switch
2. Remove the Spring, the Lens, and the Heatsink
3. Install the MR16 lamp
4. Reverse steps 1 and 2.
OPTIONAL ACCESSORIES:
Lens (Specialty lenses may be ordered separately)
Replacing the Lens
1. Squeeze the ends of the spring together
and remove spring and lens
2. Replace lens and snap spring back into
position
Framing Projector and Barn Doors (Ordered separately)
Installing Framing Projector or Barn Doors
These accessories are simply press-fitted by hand into the front of the fixture. Lens should be installed prior.
Heatsink
MR16
Lens
Spring
Framing Projector Barn Doors
Loading...