INSTRUCTIONS Line Voltage Track Fixture
Lamp
ing:
Fixture Inst
allation:
rotated, they will face the grooved side of the track (this
ts length).
Retain these instructions for future service and adjustments
Models: HTK-793 HTK-794 HTK-795
Caution:
Read all instructions before installing.
Switch off power before installing or re-lamping.
Do not attempt to energize anything other than a track light fixture.
All installation shall be in accordance with NEC and all local codes.
To reduce the risk of a burn during re-lamping, remove from the track before re-lamping.
Overview:
Fixtures are designed for use on “HT” series WAC Lighting track. They may also be used on other
manufacturer’s brand of track (consult factory for compatibility).
1. HTK-793 use PAR 20 lamp, 50W max.
HTK-794 use PAR 30 lamp, 75W max.
HTK-795 use PAR 38 lamp, 150Wmax.
2. Insert the PAR lamp by screwing clockwise
into lamp socket.
1. Note the track head contacts, and the polarity groove
running the length of the track.
2. The two contacts should be positioned so that when
is the side with two flat copper wires running i
3. Insert adapter into track slot. Pull downward on the
adapter while rotating the adapter 90º.
4. Release the adapter so the locking tab seats in the
track slot.
5. Removal is the reverse procedure. Track heads may
be positioned anywhere along the track length.
6. Not suitable for use on wall mounted track.
Retain instructions for future reference.
615 South Street, Garden City, NY 11530
Tel: (516) 515-5000 Fax (516) 515-5050
www.waclighting.com
INSTRUCTIONS Line Voltage Track Fixture
Lamp
ing:
Fixture Installation:
may be positioned anywhere along the track length.
Retain these instructions for future service and adjustments
Models: JTK-793 JTK-794 JTK-795
Caution:
Read all instructions before installing.
Switch off power before installing or re-lamping.
Do not attempt to energize anything other than a track light fixture.
All installation shall be in accordance with NEC and all local codes.
To reduce the risk of a burn during re-lamping, remove from the track before re-lamping.
Overview:
Fixtures are designed for use on “JT/J2T” series WAC Lighting track.
They may also be used on other manufacturer’s brand of track (consult factory for compatibility).
3. JTK-793 use PAR 20 lamp, 50W max.
JTK-794 use PAR 30 lamp, 75W max.
JTK-795 use PAR 38 lamp, 150Wmax.
4. Insert the PAR lamp by screwing clockwise into
lamp socket.
7. Note the track has a groove running its length to
indicate polarity.
8. Note the arrow on the locking tab.
9. Insert adapter into track slot and rotate it 90°. The
arrow should point to the grooved side of the track.
10. Make sure the locking tab seats in the track slot.
11. Removal is the reverse procedure. Track heads
Retain instructions for future reference.
615 South Street, Garden City, NY 11530
Tel: (516) 515-5000 Fax (516) 515-5050
www.waclighting.com
Loading...