Vutec ELEGANTE MOTORIZED Installation Instructions

Elegante-Rev H 08/30/2010

1

INSTALLATION INSTRUCTIONS

Elegante Projection Screen

PLEASE READ THESE IMPORTANT SAFETY INSTRUCTIONS

• Read and understand all instructions before installing and using.

• The Elegante Projection Screen meets requirement for fire-resistant and low smoke-producing characteristics.

• Close supervision is necessary when Projection Screen is used by or near children. Do not leave Screen unattended while

in used.

• Installer must ensure that the mounting structures and fasteners must be of adequate strength to securely support the

screen so that vibrations or even abusive pulling on the screen surface will not cause the housing to work loose or fall.

• The Screen Switch is provided with the symbols “O” indicating OFF, “-”indicating ON-UP and “=” indicating ON-

DOWN.

•

Do not operate Screen with a damage cord or if the Screen has been dropped or damage – until it has been examined by a
qualified serviceman.

DO NOT place or attach anything to metal casing or viewing screen.

•

Position cord so that it will not be tripped over, pulled, or contact hot surfaces.

•

DO NOT plug the cord in with wet hands; electric shock could occur

•

•

DO NOT under any circumstances cut or remove the third (Ground) prong from power cord. For personal safety, this
Projection Screen must be properly grounded.

•

Always unplug Projection Screen from electrical outlet before cleaning and servicing and when not in use. Never Yank
cord to pull cord from outlet. Grasp plug and pull to disconnect.

To reduce the risk of electric shock, do not dissemble this Projection Screen, but take it to a qualified serviceman when

•

service or repair is required. Incorrect reassembly can cause electric shock when Screen is used subsequently,

Cord and Plug Installation Safety Instructions

• The length of power cord used in this Projection Screen was selected to reduce the hazards of becoming tangled in, or

tripping over a longer cord.

• We strongly recommend against the use of an extension cord.

• If an extension cord is necessary, it is absolutely necessary that it is UL-Listed, 3-wire grounding type appliance

extension cord having a grounding type plug and outlet. The electrical rating of the extension cord must be equal or
greater that the rating of the projection screen.

• Always unplug Projection Screen from electrical outlet before cleaning and servicing and when not in use. Never Yank

cord to pull cord from outlet. Grasp plug and pull to disconnect.

• Always connect this Projection Screen to a grounded outlet. Outlet–socket should be located near Screen and shall be

easily accessible

“SAVE THESE INSTRUCTIONS”

Elegante-Rev H 08/30/2010

2

General Installation Notes

The Elegante screen can be mounted on a wall, ceiling or suspended from ceiling. The Elegante Projection Screen meets
requirement for fire-resistant and low smoke-producing characteristics.

The screen surface is centered in the housing
The brackets should be mounted into studs or blocking in the wall/ceiling or in drywall (minimum thickness [1/2”] with specified

anchors (not supplied). For any other type of installation and other types on non-wood frame construction, the selection of
appropriate mounting hardware should be made by a qualified installer and it should follow all local building and safety codes

Determine bracket location per instructions in Figure 1a. And configure mounting kit according to mounting preferences show in
“Figure 1c” for Wall mount, “Figure 1d” for ceiling mount or “Figure 1e” for ceiling suspended mount.

The mounting structures and fasteners must be of adequate strength to support the screen even abusive pulling on the screen surface
will not cause the housing to work loose or fall. Housing must be mounted level

Figure 1a

Figure 1b

Wall Installation

Figure 1c

Ceiling Installation

Figure 1d

Suspended Installation

Figure 1e