Vuly Nest Swing Large Assembly Manual

Nest Swing – Large

You must attach your Nest Swing - Large only in the configurations shown below - to a

PRE-INSTALLATION

WARNING!

Medium or Large swing set configuration with capacity for two or three standard swings

side by side.

You must not attach onto a Small swing set (with capacity for only one standard swing).

ASSEMBLY MANUAL

STEP

A.

B.

1

Remove a Locking Bolt from both Rail Brackets and slip
them over the Swing Rail where you want to attach your
Nest Swing.

Ensure that they are 1.2 m apart.

Reinsert the Locking Bolts and tighten the bolts firmly
– until you notice the rubber beginning to squeeze – to
secure the Rail Bracket.

STEP

Insert each Tube into the foam that’s inside the four
separate sections around the rim of the Base Material.
Hold the foam as you do so, to ensure that it doesn’t slide
out of the base material.

Ensure that male and female ends of adjacent Tubes are
next to each other and that you have not pushed the foam
out of the Base Material.

2

Nest Swing – Large

ASSEMBLY MANUAL

STEP

A.

B.

STEP

3

Connect the Tubes to each other to complete the ring.

Sit the Base Material and Tubes flat on the ground, and
align the holes in the connected tubes.

4

STEP

5

VULY MINI:

Remove the first set of carabiners and the Height

A.

Adjustment Straps on both sides of the Swing.

Unlock the carabiners on your Swing, and hook them

B.

into the lugs on the Rail Brackets.

Ensure that both carabiners are facing the same
direction and have been firmly tightened.

VULY MAX:

Unlock the carabiners on your Swing, and hook them into
the lugs on the Rail Brackets.

Ensure that both carabiners are facing the same direction
and have been firmly tightened.

Thread the bolt with the ropes to hang the swing through
the holes on the completed ring, and fasten.

CONGRATULATIONS!

You have attached the Nest Swing - Large to your Swing Set.