Item # __________________________
C.S.I. Section 11420
MODEL V0-36
HEAVY DUTY GAS OVEN
■■ V0-36 With standard oven
■■ V0-36C With convection oven
STANDARD FEATURES
■ Stainless steel front, front top ledge and 6" stub back.
■ Stainless steel 6" adjustable legs.
■ Sides finished in black epoxy powder coat paint.
1
/4" diameter front gas manifold.
■ 1
■ Stainless steel top work surface.
■ Standard oven (V0-36): 40,000 BTU/hr. burner with pilot
ignition. Porcelain enamel on steel oven hearth, rear panel and
door liner. One oven rack with four positions. Thermostat
adjusts from 250° to 500°F. Oven controls located in the cool
zone. Counterbalanced oven door. Oven interior measures
1
/2"w x 281/2"d x 141/2"h.
27
■ Convection oven (V0-36C): 30,000 BTU/hr. burner with
electronic ignition. Porcelain enamel on steel oven cavity.
Three oven racks with four rack positions. Thermostat adjusts
from 200° to 500°F. Oven controls located in the cool
zone. Counterbalanced oven door.
6' power cord and plug. 115 volt, 60 Hz, 1 ph, 4 amps. Oven
interior measures 26
1
/4"w x 23"d x 14"h.
■ Oven door counterbalanced with weights.
■ One year limited parts and labor warranty.
1
/4 H.P. blower-motor with
Vulcan-Hart Co.
ISO9001
A2780
MODELS: V0-36 SERIES
SPECIFICATIONS:
Heavy duty oven with stainless steel top work surface, VulcanHart Model No. V0-36. Stainless steel front, front top ledge, 6"
high stub back and 6" adjustable legs. Sides finished in black
epoxy powder coat paint. 1
1
/4" diameter front gas manifold.
Exterior dimensions: 36"w x 38"d x 36" working height on 6"
adjustable legs.
CSA design certified. NSF listed.
SPECIFY TYPE OF GAS AND FINISH WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 2,000 FT.
OPTIONS
■■ 30,000 BTU/hr. Snorkel convection oven,
1
/4 H.P. blowermotor with 6' power cord and plug in place of standard oven,
115/60/1, 4 amps.
■■ Stainless steel side(s). ■■ Left ■■ Right
■■ Stainless steel finishing back.
■■ Cap and cover manifold end(s). ■■ Left ■■ Right
■■ Leveling bolts in place of legs for curb mounting.
■■ Stainless steel dolly frame with casters, up to 72" wide.
3
■■ Rear gas connection. ■■
/4" (includes gas pressure regu-
lator) or ■■ 11/4"
■■ Common stainless steel front top ledge up to 96" wide.
(Drawing required showing the position of each piece of
equipment.)
ACCESSORIES
■■ Set of four 5" diameter casters, (2 locking).
■■ 11/4" gas pressure regulator.
■■ 261/2" or 373/4" high stainless steel backguard. (Available up to
72" wide.)
1
/2" high single deck high shelf. (Available up to 72" wide.)
■■ 26
1
/2" high single deck flo-thru shelf. (Available up to 72" wide.)
■■ 26
■■ 373/4" high double deck high shelf. (Available up to 72" wide.)
■■ Flexible gas hose with quick disconnect and restraining
device. Consult price book for available sizes.
Heavy Duty Gas Oven
F-32491 (10-03)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
IMPORTANT
1. A properly sized gas pressure regulator suitable for battery or
single unit application must be furnished and installed.
Natural gas 5.0" W.C., propane gas 10.0" W.C.
2. An adequate ventilation system is required for commercial
cooking equipment. Information may be obtained by writing to
the National Fire Protection Association, Batterymarch Park,
Quincy, MA 02269. When writing refer to NFPA No. 96.
3. These units are manufactured for installation in accordance
with ANSZ223.1a (latest edition), National Fuel Gas Code.
Copies may be obtained from the American Gas Association,
1515 Wilson Blvd., Arlington, VA 22209.
MODELS V0-36
HEAVY DUTY GAS OVEN
4. Clearances: Combustible Non-Combustible
Rear 2" 0"
Sides 20" 2"
5. For proper combustion, install equipment on adjustable legs
or casters. On curb or platform, allow 3
Leveling bolts are required for curb installation. Specify when
ordering.
6. Cannot be batteried with GH series equipment.
7. This appliance is manufactured for commercial installation
only and is not intended for home use.
1
/2" front overhang.
GAS RATED INPUT BTU/HR.
MODEL
NO. TOP OVEN TOTAL WIDTH DEPTH ON 6" LEGS (lbs./kg)
V0-36 — 40,000 40,000
V0-36C — 30,000 30,000 580/261
NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and
specifications without notice.
F-32491 (10-03)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
36" 38" 36"
WORKING APPROX.
HEIGHT SHP. WT.
540/243
Printed On Recycled Paper