Vulcan Hart MSA36, MSA60, MSA72 General Manual
GRIDDLES & BROILERS
Model MSA48
SPECIFICATIONS
Low prole heavy duty gas griddle, Vulcan Model No._______.
Stainless steel front, sides and front top ledge. Fully welded
stainless and aluminized steel body frame. 11" low prole
cooking height on 4" legs. 1" thick polished steel griddle
plate with 12 gage, 4" stainless steel back and tapered side
splashes. Grease chute is fully welded to stop grease migration.
One 27,000 BTU/hr. “U” shaped aluminized steel burner and
mechanical snap action thermostat for each 12" of griddle
width. Chrome thermostat knob guards. Temperature adjusts
from 200° to 550° F. One pilot safety for every two burners.
3½" wide stainless steel grease trough. ¾" rear gas connection
and gas pressure regulator.
Exterior Dimensions:
_____"w x 33" d x 15½" h on 4" legs.
CSA design certied. NSF listed.
SPECIFY TYPE OF GAS WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 3,999 FT.
Item # C.S.I. Section 11420
MSA SERIES
HEAVY DUTY GAS GRIDDLES
MSA24 24" w x 24" d griddle plate
MSA36 36" w x 24" d griddle plate
MSA48 48" w x 24" d griddle plate
MSA60 60" w x 24" d griddle plate
MSA72 72" w x 24" d griddle plate
STANDARD FEATURES
Stainless steel front, sides and front top ledge with “Cool ■
Bullnose” design.
Fully welded stainless and aluminized steel chassis frame. ■
11" low prole cooking height on 4" adjustable legs. ■
1" thick polished steel griddle plate with 12 gage, ■
4" stainless steel back and tapered side splashes.
Spatula wide 3½" grease gutter and chute is fully welded ■
for easier cleaning and to stop grease migration.
One 27,000 BTU/hr. “U” shaped aluminized steel burner for ■
every 12" of griddle width.
One embedded snap action thermostat per burner with ■
temperature adjust from 200°F to 550°F.
Large 6 quart stainless steel grease drawer (2 drawers on ■
60" and 72" models).
Heavy duty chromed thermostat knob guards. ■
One pilot safety valve for every two burners. Safety will ■
completely shut off gas to pilot and burners if pilot
extinguishes.
Manual ignition. ■
Bottom heat shields. ■
¾" rear gas connection and gas pressure regulator. ■
One year limited parts and labor warranty. ■
OPTIONAL FE ATURES
Hexavalent chrome plated cooking surface.
30" deep plate.
Stainless steel stand with marine edges and casters.
Cutting board, condiment rail, plate rail and banking strip
accessories.
Full or partially grooved griddle plate.
a divisi on of ITW Food Equ ipment G roup LLC
P.O. Box 696 ■ Louisville, KY 40201 ■ Toll-free: 1-800-814-2028 ■ Local: 502-778-2791 ■ Quote & Order Fax: 1-800-444-0602
F-38314 (03/10)
INSTALL ATION INSTRUCTI ONS
GRIDDLES & BROILERS
MSA SERIES
HEAVY DUTY GAS GRIDDLES
1. A gas pressure regulator supplied with the unit must be installed;
Natural Gas 4.0" (102 mm) W.C.
Propane Gas 10.0" (254 mm) W.C.
2. All models require a 6" (152 mm) clearance at both sides and
rear adjacent to combustible and 0" from non-combustible
constructions. All models require a 4" (102mm) bottom clearance
and must be installed with minimum 4" legs.
3. These units are manufactured for installation in accordance with
ANSI/NFPA-70, National Electrical code.
An adequate ventilation system is required for Commercial
Cooking Equipment (NFPA No. 96). Information may be
obtained by writing to the National Fire Protection Association,
Batter ymarch Park, Quincy, MA 02169.
4. These units are manufactured for installation in accordance with
National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition).
Copies may be obtained from The American Gas Association,
Accredited Standards Committee Z223 @ 400 N. Capital St. NW,
Washington, DC 20001, or the Secretary Standards Council,
NFPA, 1 Batterymarch Park, Quincy, MA 02169-7471.
NOTE: In The Commonwealth of Massachusetts
All gas appliances vented through ventilation hood or exhaust
system equipped with a damper or with a power means of
exhaust shall comply with 248 CMR.
5. This appliance is manufactured for commercial installation only
and is not intended for home use.
FRONT VIEW
MODEL WIDTH DEPTH
OVERALL
HEIGHT*
WORKING
HEIGHT*
NO. OF
BURNERS
TOTAL
BTU/HR.
SIDE VIEW
NO. OF
DRAWERS
APPROX.
SHIP. WT.
MSA24 24" 311⁄2" 151⁄4" 111⁄8" 2 54,000 1 285 lbs./129 kg.
MSA36 36" 311⁄2" 151⁄4" 111⁄8" 3 81,000 1 400 lbs./181 kg.
MSA48 48" 311⁄2" 151⁄4" 111⁄8" 4 108,000 1 480 lbs./218 kg.
MSA60 60" 311⁄2" 151⁄4" 111⁄8" 5 135,000 2 650 lbs./295 kg.
MSA72 72" 311⁄2" 151⁄4" 111⁄8" 6 162,000 2 790 lbs./358 kg.
*These are nominal dimensions and can vary by +1.75" with adjustable legs.
a divisi on of ITW Food Equ ipment G roup LLC
P.O. Box 696 ■ Louisville, KY 40201 ■ Toll-free: 1-800-814-2028 ■ Local: 502-778-2791 ■ Quote & Order Fax: 1-800-444-0602
F-38314 (03/10)
NOTE: In line w ith its policy to co ntinua lly impr ove its pro ducts , Vulcan r eser ves the ri ght to cha nge mate rials a nd specicat ions without notice.
Loading...