Vulcan 924RX User Manual
GRIDDLES & BROILERS
HEAVY DUTY GAS GRIDDLES
Model 948RX
SPECIFICATIONS
Low prole heavy duty gas griddle, Vulcan Model No.___ ___ _.
Stainless steel front, sides and front top ledge. Fully welded
stainless and aluminized steel body frame. 11" low prole
cooking height on 4" legs. 1" thick polished steel griddle
plate with 12 gage, 4" stainless steel back and tapered side
splashes. Grease chute is fully welded to stop grease migration.
One 27,000 BTU/hr. “U” shaped aluminized steel burner and
mechanical snap action thermostat for each 12" of griddle
width. Chrome thermostat knob guards. Temperature adjusts
from 200° to 550° F. One pilot safety for every two burners.
Manual shut-off valve. 3½" wide stainless steel grease trough.
120V 50/60Hz 1 Amp single phase electric ignition circuit.
Plug type is NEMA 5-15 USA. ¾" rear gas connection and gas
pressure regulator.
Exterior Dimensions:
_____"w x 33" d x 15½" h on 4" legs.
CSA design certied. NSF listed.
SPECIFY TYPE OF GAS WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 3,999 FT.
Item # C.S.I. Section 11420
900RX SERIES
924RX 24" w x 24" d griddle plate
936RX 36" w x 24" d griddle plate
948RX 48" w x 24" d griddle plate
960RX 60" w x 24" d griddle plate
972RX 72" w x 24" d griddle plate
STANDARD FEATURES
■ Stainless steel front, sides and front top ledge with “Cool
Bullnose” design.
■ Fully welded stainless and aluminized steel chassis frame.
■ 11" low prole cooking height on 4" adjustable legs.
■ 1" thick polished steel griddle plate with 12 gage,
4" stainless steel back and tapered side splashes.
■ Spatula wide 3½" grease gutter and chute is fully welded
for easier cleaning and to stop grease migration.
■ One 27,000 BTU/hr. “U” shaped aluminized steel burner for
every 12" of griddle width.
■ One embedded snap action thermostat per burner with
temperature adjust from 200°F to 550°F.
■ Large 6 quart stainless steel grease drawer (2 drawers on
60" and 72" models).
■ Heavy duty chromed thermostat knob guards.
■ One pilot safety valve for every two burners. Safety will
completely shut off gas to pilot and burners if pilot
extinguishes.
■ Manual shut-off valve for gas inlet.
■ Dual (manual/electric) ignition.
■ Bottom heat shields
■ ¾" rear gas connection and gas pressure regulator.
■ 120V 50/60Hz 1 Amp single phase with NEMA 5-15 USA
plug.
■ One year limited parts and labor warranty.
OPTIONAL FEATURES
Hexavalent chrome plated cooking surface.
30" deep plate.
Stainless steel stand with marine edges and casters.
Cutting board, condiment rail, plate rail and banking strip
accessories.
Full or partially grooved griddle plate.
a divisi on of IT W Food Equ ipment Group LLC
P.O. Box 696 ■ Louisville, KY 40201 ■ Toll-free: 1-800-814-2028 ■ Local: 502-778-2791 ■ Quote & Order Fax: 1-800-444-0602
F38303 (08/14)
INSTALLATION INSTRUCTIONS
GRIDDLES & BROILERS
900RX SERIES
HEAVY DUTY GAS GRIDDLES
1. A gas pressure regulator supplied with the unit must be installed;
Natural Gas 4.0" (102 mm) W.C.
Propane Gas 10.0" (254 mm) W.C.
2. All models require a 6" (152 mm) clearance at both sides and
rear adjacent to combustible and 0" from non-combustible
constructions. All models require a 4" (102mm) bottom clearance
and must be installed with minimum 4" legs.
3. These units are manufactured for installation in accordance with
ANSI/NFPA-70, National Electrical code.
An adequate ventilation system is required for Commercial
Cooking Equipment (NFPA No. 96). Information may be
obtained by writing to the National Fire Protection Association,
Batter ymarch Park, Quincy, MA 02169.
4. These units are manufactured for installation in accordance with
National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition).
Copies may be obtained from The American Gas Association,
Accredited Standards Committee Z223 @ 400 N. Capital St. NW,
Washington, DC 20001, or the Secretar y Standards Council,
NFPA, 1 Batterymarch Park, Quincy, MA 02169-7471.
NOTE: In The Commonwealth of Massachusetts
All gas appliances vented through ventilation hood or exhaust
system equipped with a damper or with a power means of
exhaust shall comply with 248 CMR.
5. This appliance is manufactured for commercial installation only
and is not intended for home use.
FRONT
GREASE
TROUGH SIDE VIEW
FRONT VIEW
MODEL WIDTH DEPTH
OVERALL
HEIGHT*
WORKING
HEIGHT*
NO. OF
BURNERS
TOTAL
BTU/HR.
NO. OF
DRAWERS
REAR
GREASE
TROUGH SIDE VIEW
APPROX.
SH I P. W T.
924RX 24" 311⁄2" 151⁄4" 111⁄8" 2 54,000 1 285 lbs. /129 kg.
936RX 36" 311⁄2" 151⁄4" 111⁄8" 3 81,000 1 400 lbs. /181 kg.
948RX 48" 311⁄2" 151⁄4" 111⁄8" 4 108,000 1 480 lbs. /218 kg.
960RX 60" 311⁄2" 151⁄4" 111⁄8" 5 135,000 2 650 lbs. /295 kg.
972RX 72" 311⁄2" 151⁄4" 111⁄8" 6 162,000 2 790 lbs. /358 kg.
*These are nominal dimensions and can vary by +1.75" with adjustable legs.
a divisi on of IT W Food Equ ipment Group LLC
P.O. Box 696 ■ Louisville, KY 40201 ■ Toll-free: 1-800-814-2028 ■ Local: 502-778-2791 ■ Quote & Order Fax: 1-800-444-0602
F38303 (08/14)
NOTE: In line w ith its policy to co ntinua lly imp rove its pr oduct s, Vulca n reser ves the right to c hange materia ls and sp ecic ation s withou t notice.
Loading...