Vulcan 924RE User Manual
Item # __________________________
C.S.I. Section 11420
900RE SERIES
LOW PROFILE HEAVY-DUTY GAS GRIDDLE
■ 924RE 24" w x 24" d griddle plate
■ 936RE 36" w x 24" d griddle plate
■ 948RE 48" w x 24" d griddle plate
■ 960RE 60" w x 24" d griddle plate
■ 972RE 72" w x 24" d griddle plate
Model 924RE
SPECIFICATIONS:
Low profile heavy duty gas griddle, Vulcan-Hart Model
No. ________. Stainless steel front, sides and 4" front top ledge.
Fully welded stainless and aluminized steel body frame. 11" low
profile cooking height on 4" legs. 1" thick polished steel griddle
plate welded to stainless steel back and tapered side splashers.
One 30,000 BTU/hr. “U” shaped aluminized steel burner and
120 volt snap action thermostat for each 12" of griddle width.
Temperature adjusts from 150° to 450°F. Electronic ignition.
31/2" wide stainless steel front grease trough. Large capacity
67/8" wide x 30" deep x 21/2" high stainless steel grease drawer.
3
/4" rear gas connection and gas pressure regulator. 120 volt
control circuit, 6' cord with 3 prong plug.
Exterior dimensions: _____" w x 33" d x 151/2" h on 4" legs.
CSA design certified. NSF listed.
SPECIFY TYPE OF GAS WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 2,000 FT.
STANDARD FEATURES
■ Stainless steel front, sides and 4" front top ledge.
■ Fully welded stainless and aluminized steel body frame.
■ 11" low profile cooking height on 4" adjustable legs.
■ 1" thick polished steel griddle plate welded to stainless steel
back and tapered side splashers.
■ One 30,000 BTU/hr. “U” shaped aluminized steel burner and
120 volt snap action thermostat for each 12" of griddle width.
Temperature adjusts from 150° to 450°F.
■ Electronic ignition.
■ 31/2" wide stainless steel front grease trough.
■ Large capacity 67/8" wide x 30" deep x 21/2" high stainless
steel grease drawer.
■ 3/4" rear gas connection and gas pressure regulator. 120 volt
control circuit, 6' cord with 3 prong plug.
■ One year limited parts and labor warranty.
OPTIONS
■ Leg Lengths: 4", 55⁄8", 8", 10", 113⁄4".
■ Chrome-plated cooking surface.
■ Rear grease trough.
■ Full or partially grooved griddle plates.
■ Stainless steel stand with marine edges and casters.
■ Towel bar.
■ Full width cutting board.
■ 30˝ deep plate.
A2780
ISO9001
Vulcan-Hart Co.
MODEL: 900RE SERIES Low Profile Heavy-Duty Gas Griddle
F-32618 (4-07)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
900RE SERIES
LOW PROFILE HEAVY-DUTY GAS GRIDDLE
IMPORTANT
1. A gas pressure regulator supplied with the unit must be
installed:
Natural Gas 5.0" (127 mm) W.C.
Propane Gas 10.0" (254 mm) W.C.
2. All models require a 6" (152 mm) clearance at both sides and
rear adjacent to combustible constructions and 0" from noncombustible constructions. All models require a 4" (102 mm)
bottom clearance and must be installed with minimum 4" legs.
3. These units are manufactured for installation in accordance
with ANSI/NFPA-70, National Electrical code.
An adequate ventilation system is required for Commercial
Cooking Equipment (NFPA No. 96). Information may be
obtained by writing to the National Fire Protection Association,
Batterymarch Park, Quincy, MA 02269.
4. These units are manufactured for installation in accordance
with National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest
edition). Copies may be obtained from The American Gas
Association, Accredited Standards Committee Z223 @ 400N.
Capital St. NW, Washington, DC 20001, or the Secretary
Standards Council, NFPA, 1 Batterymarch Park, Quincy, MA
02169-7471.
NOTE: In the Commonwealth of Massachusetts
All gas appliances vented through a ventilation hood or exhaust
system equipped with a damper or with a power means of
exhaust shall comply with 248 CMR.
5. This appliance is manufactured for commercial installation only
and is not intended for home use.
Front View
Side View
OVERALL WORKING NO. OF TOTAL NO. OF APPROX.
MODEL WIDTH DEPTH HEIGHT* HEIGHT* BURNERS BTU/HR. DRAWERS** SHP.WT.
924RE 24" 33" 15
936RE 36" 33" 15
948RE 48" 33" 15
960RE 60" 33" 15
972RE 72" 33" 15
*These are nominal dimensions and can vary by +1.75" with adjustable legs.
**All Rear Grease option griddles have only one (1) grease drawer on the left side.
NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and
specifications without notice.
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
F-32618 (04-07)
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
¹₂" 11³₈" 2 60,000 1 285 lbs./129 kg
¹₂" 11³₈" 3 90,000 1 400 lbs./181 kg
¹₂" 11³₈" 4 120,000 1 480 lbs./218 kg
¹₂" 11³₈" 5 150,000 1 650 lbs./295 kg
¹₂" 11³₈" 6 180,000 2 790 lbs./358 kg
Loading...