Vuescape 11011005B User Manual

USB 2.0 Webcam & Microphone Headset

Item Number: 11011005B

All brand names and trademarks are the property of their respective owners

* Important Notice: Please read this manual carefully

User’s Manual

Introduction

Thank you for choosing our new generation WebCam and headphone combination. It has a high
resolution and fast transmission rate, and it is easy to transport with you for remote broadcasting.
It can be used as a Plug and Play (PnP) WebCam for real-time data transmission to PC via USB Port.

Specifications

¾ 350k pixels resolution (when used as Plug and Play)
¾ 5 Megapixel resolution (with the driver/software installed)
¾ High resolution CMOS color sensor
¾ Video mode: 24bit true color
¾ Large video capture size: 640 x 480 (when used as Plug and Play)
¾ Large video capture size: 2560 × 1920 (with the driver/software installed)
¾ Interface: USB 2.0 high-speed
¾ Transmission Rate: 640 × 480 up to 30fps
¾ Noise-signal ratio: greater than 48db (30fps 220LUX)
¾ Dynamic range: greater than 72db
¾ Image focus: 5cm to infinity
¾ Built-in image compression
¾ Automatic brightness adjustment
¾ Automatic color compensation
¾ Manual focus override

Note: Under the Windows XP Service Pack 2 operation system, please make sure you have plugged
the camera’s USB cable into the initial USB port interface controlled by the driver software. Otherwise it
will perform as a Plug and Play USB Video Device with the lower resolution and video capture size.

System Requirement

• Desktop PC or Laptop PC with USB 2.0 interface

• Pentium 200 or higher CPU

• 32MB or higher RAM memory

• Over 200MB free hard disc space

• CD ROM drive to load driver

• Compatible with Windows® XP Service Pack 1 (or higher), and Vista®.

Note: The Plug and Play feature works only with Windows® XP Service Pack 2+ and Vista®.

Package Contents

USB WebCam

Software CD

Microphone Headset

User’s Manual

Getting Started

Hardware Installation

1. Plug the audio connectors of the Microphone Headphone to the Audio and Microphone line out at

the rear of your PC.

2. Plug the USB WebCam to an available USB port on your computer.

3. Power on the computer and the monitor.

4. You may now adjust the Volume control of the Microphone Headphone to your desired setting.

Camera Installation (without driver software)

1. Verify the version of your operation system. Under Windows® XP click on Start -> click on
“Control Panel” -> double click on “System” and the System Properties will appear on the

screen.

2. If you have check out your OS is the version of Windows XP service pack 2 or above, than you
can plug the PC camera into the USB interface, on the computer will show as below picture
“Found New Hardware USB Video Device”, this is to say your PC camera hardware can be used
now.

3. Where you can preview the PC camera video capture?
Double click on “My Computer” on the desk, then you will find “USB Video Device #*” from the
following window:

4. Double click on “USB Video Device #*”, then you can preview the video capture as in the following
window, also you can take still captures here.

Camera Driver Software Installation

***Plug the PC camera USB cable into the computer interface first before you install the driver.

1. Insert the software CD to your CD-ROM drive, and locate the software Icon from the CD ROM as
shown below, double click on it to start the driver installation.

2. Software installing.