User’s Manual
Beep & Go Baby KeysTM
© 2014 VTech
Printed in China
91-002887-006
To learn more about the Infant Learning® series and her VTech® ts, visit www.vtechkids.com
INTRODUCTION
Thank you for purchasing the VTech® Beep & Go Baby KeysTM
learning toy!
Shake, rattle and roll with the VTech
toy! Baby will be introduced to sing-along songs, music and realistic
car sounds. Shaking the car rattle helps baby develop motor skills and
when the three buttons on the car are pressed, interactive responses
play. Learning has never been so much fun!
®
Beep & Go Baby KeysTM learning
MUSIC BUTTON
SOUND EFFECTS
BUTTON
LIGHT-UP BUTTON
Introduction
OFF/VOLUME
CONTROL SWITCH
3
INCLUDED IN THIS PACKAGE
• One VTech® Beep & Go Baby KeysTM learning toy
• One user’s manual
WARNING: All packing materials, such as tape, plastic sheets,
packaging locks and tags are not part of this toy,
and should be discarded for your child’s safety.
ATTENTION: Pour la sécurité de votre enfant, débarrassez-
vous de tous les produits d’emballage tels que
rubans adhésifs, feuilles de plastique, attaches
et étiquettes. Ils ne font pas partie du jouet.
NOTE: Please keep user’s manual as it contains
important information.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the
unit. Use a screwdriver to loosen the screw.
3. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover and tighten the
screw to secure.
Included In This Package
4
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
PRODUCT FEATURES
1. OFF/VOLUME CONTROL SWITCH
To turn the unit ON, slide the OFF/
VOLUME CONTROL SWITCH to the
LOW VOLUME ( ) or HIGH VOLUME
( ) position. To turn the unit OFF, slide
the OFF/VOLUME CONTROL SWITCH
to the OFF ( ) position.
2. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech® Beep & Go Baby Keys
automatically power-down after approximately 30 seconds without
input. The unit can be turned on again by pressing any button.
TM
Product Features
will
5
ACTIVITIES
1. Slide the off/volume switch to turn the
unit on. You will hear car sounds, playful
phrases and a song. The light will ash
with the sounds.
2. Press the light-up button on the front of
the car to learn colors and hear fun car
sounds and playful songs. The light will
ash with the sound.
3. Press the music button to hear melodies.
The light will ash with the sounds.
4. Press the sound effects button to hear
different sound effects. The light will
ash with the sounds.
5. Shake the car to hear short tunes and
sound effects. The light will ash with the
sounds.
Activities
6
MELODY LIST
1. London Bridge
2. Here We Go Round the Mulberry Bush
3. Skip to My Lou
4. Aiken Drum
5. Daisy Bell
6. Yankee Doodle
7. Hickory Dickory Dock
8. Did You Ever See a Lassie?
9. Hot Cross Buns
10. Georgie Porgie
11. Here We Go Looby Loo
SUNG SONG LYRICS
SONG 1
1-2-3 start the engine,
Turn the key!
We’re going on an adventure, just you and me!
SONG 2
I’m a little yellow car,
My four round wheels will take me far. Yippee!
SONG 3
Beep, beep,beep, here I come.
I like to drive, I’m number one.
Melody List & Sung Song Lyrics
7
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5. If the product still does not work, replace with a new set of batteries.
If the problem persists, please call our Consumer Services Department
at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, and a
service representative will be happy to help you.
For information on this product’s warranty, please call VTech
1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada.
IMPORTANT NOTE:
Creating and developing Infant Learning products is accompanied
by a responsibility that we at VTech
every effort to ensure the accuracy of the information, which forms
the value of our products. However, errors sometimes can occur. It
is important for you to know that we stand behind our products and
encourage you to call our Consumer Services Department at 1-800521-2010 in the U.S. or 1-877-352-8697 in Canada, with any problems
and/or suggestions that you might have. A service representative will
be happy to help you.
®
take very seriously. We make
®
at
Care & Maintenance
8
Note:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-3 (B)/NMB-3(B)
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
Other Info
9
Loading...