Vs sassoon VSM2A User Manual

i-Twin Trim
Dual BlaDe rechargeaBle Trimmer
Model VSM2A
SAFETY CAUTIONS WARNING! Polythene bags over the product or packaging may be
dangerous. To avoid danger of suffocation, keep away from babies and children. These bags are not toys.
• This appliance should only be used as described within this instruction
• Do not immerse the appliance in water or other liquids.
• Always inspect the appliance before use for noticeable signs of damage. Do not use if damaged or if the
appliance has been dropped. In the event of damage contact the Conair Customer service line 1800 650 263
• Only use the attachments supplied with this appliance.
• Do not leave the appliance unattended when switched on.
• Do not place the appliance on any surface whilst in operation.
• Special care is required when using the appliance close to the ears,
eyes and face.
• This appliance should not be used by adults whose reduced physical,
sensory or mental capabilities, or whose lack of experience and knowledge, might cause a hazard, unless they have been correctly instructed to understand the safe use and hazards involved and are
adequately supervised.
• Careful adult supervision is required when this appliance is used on or near children. Do not use on very young children.
• This appliance should not be used, cleaned or maintained by children.
Keep out of reach of children.
• Always ensure that this appliance is kept out of the reach of children
at all times, particularly during use and whilst cooling.
• Allow the appliance to cool before storing away.
• The battery should be removed for safe disposal at the end of its life.
• When the battery has run down, it should be disposed of at a
recycling centre to safeguard the environment. If the battery leaks, avoid touching it and dispose of it at a recycling centre.
all-in-one BeaRD & MUSTaCHe TRiMMeR
Dual trimming blade
Multi-use trimmer
Stubble
comb
Lubricating
oil
5-position
comb attachment
Upper trimming
blade
3 jawline
combs
Storage stand
Single trimming
blade
SAvE ThESE INSTRUCTIONS USER MANUAL
Before using the Class 2 Power Supply, read these instructions carefully. Use with adapter CA51 Rated input voltage: 100–240V AC, 50/60Hz, 0.2A Max Rated output: 6.0VDC, 70mA
OPERATION
1. For dry location use only. Do not expose to water.
2. When not in use, unplug unit completely.
3. Unit will become warm during operation.
CAUTION
1. Dry location use only. Do not expose to liquid, vapor, or rain.
2. Do not short the polarity (output cord). Ensure jack is plugged into the
trimmer unit before plugging the adapter into the outlet.
3. Do not operate any appliance that has a damaged output cord or
housing.
4. Always unplug the unit before cleaning or when not in use.
5. This power unit is intended to be correctly oriented in a vertical or
floor mount position.
6. Be sure voltage is correct before plugging in.
TROUbLEShOOTING
If your rechargeable trimmer does not seem to be taking a charge, take the following troubleshooting steps before returning it for repair:
1. Be sure the electrical outlet is working by plugging in another
appliance to test the outlet.
2. Make sure the electrical plug is not connected to a switch that turns
power off when lights are turned off.
3. Make sure the adapter is properly connected
to the trimmer, that
all connections are secure, and that the trimmer switch is in the OFF
position.
OPERATING INSTRUCTIONS
1. Before using the trimmer for the first time, charge continuously for
16 hours. Maximum battery capacity will only be reached after 3 charging and discharging cycles.
2. Always check to see if the charging light is on when you connect the
adapter to the trimmer.
3. Plug the adapter into any wall outlet (at the voltage listed on the label
affixed to the adapter). Unplug adapter when not in use.
4. The adapter may become warm while charging. This is normal.
5. Preserving the batteries: in order to maintain the optimum capacity
of the rechargeable batteries, the clipper should be recharged for 16 hours approximately every 3 months.
6. This trimmer comes with a detachable trimmer head. To remove, make
sure the trimmer is in the OFF position, turn the head counterclockwise
until “I” mark aligns with “arrow” mark on the back of the body and then pull up. To attach trimmer head, align the “I” mark with the “arrow” mark and then turn clockwise until the “I” and “circle” marks align.
(see Fig. 1). Make sure that the motor spindle is positioned in the actuator arm when reattaching the trimmer (see Fig. 2).
Fig. 1
Fig. 2
Loading...
+ 11 hidden pages