P2 Page&Point
Instruction Manual
Manuel d’utilisation
Bedienungsanleitung
Manuale d’istruzioni
Manual de instrucciones
Gebruiksaanwijzing
Bruksanvisning
Manual de Instruções
Instrukcja obsługi
Руководствo по зкcплyатации
Návod k obsluze
Használati útmutató
Specications
Range
Frequency
Radio Classication
RF Maximum Output
Wavelength
Power Level
Laser Classication
Laser Distance
System Requirement
Material
Colour
Nobo P² Page & Point
Up to 8m
2.4 GHz Wireless Technology
Class 1 Radio Equipment
1 mW
650nm
Less than 1 mW
Class II Laser Product in
compliance with EN60825-1
Up to 200m
PC running Windows
SE or later or Macintosh®
computer with USB port
running Mac® OS 9 or later.
Painted ABS Plastic
Dark Blue
®
98
Features
Your new Nobo P² Page & Point contains many features:
• Page Up Page Down buttons, enabling you to move forwards
and backwards in your presentation.
• A high quality laser pointer incorporating advanced laser optics
and microelectronics.
• A USB receiver which slots conveniently into the end of the
Wireless Presenter for safe-keeping.
• Up to 8m of wireless range.
• Simple and easy to use – just Plug & Play.
• Compatible with most presentation applications including
®
PowerPoint.
Microsoft
• No software required.
Connecting your
P² Page & Point
Special notice
Congratulations on your purchase of a Nobo P² Page & Point, a
Wireless Presenter with built-in laser pointer which will enable you
to control your presentation from up to 8m.
Caution
Use of controls or adjustments or performance of procedures
other than those specied herein may result in hazardous
exposure.
Warning
• Do not stare into the laser beam or direct
it into another person’s eyes.
• Keep your laser pointer out of children’s
reach.
• Do not disassemble the laser pointer.
• Avoid dropping on hard surfaces.
Replacing the Batteries
Unscrew the bottom of the Nobo P² Page & Point, where the three
buttons are situated, and remove the used battery. Insert one AAA
battery. Screw back in the bottom of the Wireless Presenter.
2
m
Plug the USB receiver into your computer’s USB port. You do
not need to turn o your computer before connecting or
disconnecting the USB receiver.
Operating your
P² Page & Point
• Press the button to activate the laser pointer and release to
deactivate (x).
• Press the Page Down button (H) to move forward one slide in
your presentation.
•
Press the Page Up button (
presentation.
G) to move back one slide in your
Tips
•
First point the laser pointer at the desired information you wish
to highlight. Then switch on the laser pointer and align.
• Do not keep the laser pointer switched on for more than a few
seconds in order to keep your audience’s attention.
Warranty
The Nobo P² Page & Point is guaranteed from defect for a period
of one year from date of purchase against faulty workmanship
and materials.
Comforms with FCC
This device complies with part 15 of the FCC Rules. Operation is
subject to the follow ing two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
inter ference that may cause undesired operation.
Nobo® is a registered trademark of Acco Brands Corporation. Microsoft Oce®
and Windows® are registered trademarks of Microsoft Corporation. Apple®,
Macintosh® and Mac® are registered trademarks of Apple Corporation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the use s authority to operate
the euipment.
Attention
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
Avertissement
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipmet into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
'
m
3
Loading...