Page 1
AWM-3 QUICKSTART GUIDE
CONTROLS
VintageSynthLab.com
DRY LEVEL 1, 2, 3
Level of Unaffected Signal
Sets the level of unaffected signal.
COMPRESSION SWITCH 1, 2, 3
Switch Engages Compression
Compression is applied to incoming signal
prior to all signal routing.
POSITIVE ATTENUATION 1, 2, 3
CV Attenuation
Attenuation of incoming CV applied to
positive wavefold bias.
NEGATIVE ATTENUATION 1, 2, 3
CV Attenuation
Attenuation of incoming CV applied to
negative wavefold bias.
JACKS
POSITIVE BIAS 1, 2, 3
Threshold for Wavefolding
Sets the threshold or offset for bias
of wavefolding.
NEGATIVE BIAS 1, 2, 3
Threshold for Wavefolding
Sets the threshold or offset for bias
of wavefolding.
POSITIVE WAVEFOLD LEVEL 1, 2, 3
Sets the level of positive wavefolded signal.
NEGATIVE WAVEFOLD LEVEL 1, 2, 3
Sets the level of negative wavefolded signal.
MIX LEVEL
Sets the level of main mix output.
INPUT 1, 2, 3
Accepts any audio waveform, non-rectangular
waveformds work best for wavefolding.
OUTPUT 1, 2, 3
Each output is a mix of the Dry, Positive
and Negative Wavefold Levels.
POSITIVE MODULATION 1, 2, 3
CV Input Applied to Positive Bias
CV input that will accept input modulation
from DC to audio frequency.*
NEGATIVE MODULATION 1, 2, 3
CV Input Applied to Negative Bias
CV input that will accept input modulation
from DC to audio frequency.*
*Note: Negative jack is normaled to positive
until an input signal is applied.
MIX OUTPUT
Sum of all chanels.
MIX OUTPUT 1+2
Sum of chanels 1 and 2.
MIX OUTPUT 2+3
Sum of chanels 2 and 3.
MIX OUTPUT 1+3
Sum of chanels 1 and 3.
Made in U.S.A.VintageSynthLab.com
Loading...