Vremi VRM050696N, VRM050697N, VRM050698N, VRM050699N Users manual
This Is
A Manual.
Portable Air Conditioner
Portable Air Conditioner | 1
BEFORE FIRST USE:
To prevent any internal damage, it is very
important to keep refrigeration units
(like this one) upright throughout their
journey. Please leave it standing upright
and outside the box for 24 HOURS before
plugging it in.
In the event this product malfunctions or customer
believes it is defective, the customer should contact
Customer Service and retain the defective product
pending further instructions. Defective product should be
clearly marked or stored where it cannot be used again by
mistake. Failure to retain the product may impede Vremi’s
ability to correct any legitimate problem and may limit the
extent to which Vremi may provide recourse.
Important Safety Instructions
1. This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
2. Children shall not play with the appliance.
3. Cleaning and user maintenance shall not be made by children without supervision.
4. Disconnect the appliance from its power source during service and when replacing parts.
5. The appliance shall be installed in accordance with national wiring regulations.
6. Warning: before obtaining access to terminals, all supply circuits must be disconnected.
7. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualied
person in order to avoid a hazard.
8. Disconnect the power supply before cleaning and maintenance.
9. The appliance shall not be installed in the laundry.
10. Please note: Check the nameplate for the type of refrigerant gas used in your appliance.
11. Specic information regarding appliances with refrigerant gas. R410A, R134a, R290 is a refrigerant that complies
with European ecological standards; nevertheless, it is recommended not to pierce the cooling circuit of the
machine. At the end of its useful life, deliver the appliance to a special waste collection centre for disposal.
12. This hermetically sealed system contains uorinated greenhouse gases.
13. ENVIRONMENTAL INFORMATION: This unit contains uorinated greenhouse gases covered by the Kyoto Protocol.
14. The maintenance and disposal operations must be carried out by qualied personnel only. (For more details on
the refrigerant, see back cover). GWP(Global Warming Potential): R410A: 2088, R134a: 1430, R290: 3.
15. Do not use this unit for functions other than those described in this instruction manual.
16. If the power cord becomes worn or damaged, the cord should only be replaced by a qualied service technician
using genuine replacement parts.
17. Make sure the plug is plugged rmly and completely into the outlet. It can result in the risk of electric shock or re.
18. Do not plug other appliances into the same outlet, it can result in the risk of electric shock.
19. Do not disassemble or modify the appliance or the power cord, it can result in the risk of electric shock or re. All
other services should be referred to a qualied technician.
20. Do not place the power cord or appliance near a heater, radiator, or other heat source. It can result in the risk of
electric shock or re.
21. This unit is equipped with a cord that has a earthed wire connected to an earthed pin or grounding tab. The plug
must be plugged into a socket that is properly installed and earthed. Do not under any circumstances cut or
remove the earthed pin or grounding tab from this plug.
22. The unit should be used or store in such a way that it is protected from moisture e.g. condensation, splashed
water, etc. Unplug unit immediately if this occurs.
23. Always transport your appliance in a vertical position and place on a stable, level surface during use. If the unit is
transported laying on its side it should be stood up and left unplugged for 6 hours.
24. Always use the switch on the control panel or remote control to turn the unit off, and do not start or stop
operation by plugging in or unplugging the power cord. It can result in the risk of electric shock.
25. Do not touch the buttons on the control panel with your wet and damp ngers.
26. Do not use hazardous chemicals to clean or come into contact with the unit. To prevent damage to the surface
nish, use only a soft cloth to clean the appliance. Do not use wax, thinner, or a strong detergent. Do not use the
unit in the presence of inammable substance or vapour such as alcohol, insecticides, gasoline, etc.
Portable Air Conditioner | 4
Important Safety Instructions
27. Young children should be supervised to ensure that they do not play with, operate or climb on the appliance.
28. If the appliance is making unusual sounds or is emitting smoke or an unusual odor, unplug it immediately.
29. Do not clean the unit with water. Water can enter the unit and damage the insulation, creating a shock hazard. If
water enters the unit, unplug it immediately and contact Customer Service.
30. Utilize two or more people to lift and install the unit.
31. Be sure all accessories are removed from the packing before use.
32. To avoid possible cuts, avoid contacting the metal parts of the appliance when removing or re-installing the lter.
It can result in the risk of personal injury.
33. Do not block the air inlet or outlet of the appliance. Reduced air ow will result in poor performance and could
damage the unit.
34. Always grasp the plug when plugging in or unplugging the appliance. Never unplug by pulling on the cord. It
can result in the risk of electrical shock and damage.
35. Install the appliance on a sturdy, level oor capable of supporting up to 110lbs(50kg). Installation on a weak or
unlevel oor can result in the risk of property damage and personal injury.
36. Close all doors and windows to the room for most efcient operation.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Portable Air Conditioner | 5
Important Safety Instructions
IMPORTANT - GROUNDING METHOD
This product is factory equipped with a power supply cord that has a three-pronged grounded plug. It must be
plugged into a mating grounding type receptacle in accordance with the National Electrical Code and applicable
local codes and ordinances. If the circuit does not have a grounding type receptacle, it is the responsibility and
obligation of the customer to exchange the existing receptacle in accordance with the National Electrical Code
and applicable local codes and ordinances. The third ground prong should not, under any circumstances, be cut
or removed. Never use the cord, the plug or the appliance when they show any sign of damage. Do not use your
appliance with an extension cord unless it has been checked and tested by a qualied electrical supplier. Improper
connection of the grounding plug can result in risk of re, electric shock and/or injury to persons associated with the
appliance. Check with a qualied service representative if in doubt that the appliance is properly grounded.
ELECTRICAL CONNECTIONS
Before plugging the appliance into the mains socket, check that:
1. The mains power supply corresponds to the value indicated on the rating plate on the back of the appliance.
2. The power socket and electrical circuit are adequate for the appliance.
3. The mains socket matches the plug. If this is not the case, have the plug replaced.
4. The mains socket is adequately earthed. Failure to follow these important safety instructions absolves the
manufacturer of all liability.
Important information for correct disposal of the product in accordance with EC Directive 2012/19/EU.
At the end of its working life, the product must not be disposed of as urban
waste. It must be taken to a special local authority differentiated waste collection
centre or to a dealer providing this service. Disposing of a household appliance
separately avoids possible negative consequences for the environment and
health deriving from inappropriate disposal and enables the constituent
materials to be recovered to obtain signicant savings in energy and resources.
As a reminder of the need to dispose of household appliances separately, the
product is marked with a crossed-out wheeled dustbin.
DISPOSAL
Do not dispose of this product as unsorted municipal waste. Collection of such waste separately for special treatment
is necessary.
It is prohibited to dispose of this appliance in domestic household waste.
For disposal, there are several possibilities:
1. The municipality has established collection systems where electronic waste can be disposed free of charge.
2. As old products contain valuable resources, they can be sold to scrap metal dealers.
Wild disposal of waste in forests and landscapes endangers your health. Hazardous substances leak into the
groundwater and nd their way into the food chain.
SAVE THESE INSTRUCTIONS
For Household Use Only
Portable Air Conditioner | 6
Parts Description
DESCRIPTION
1. Deector
2. Air outlet grille
3. Display screen
4. Handle (both sides)
5. Intake grille
6. Castors
7. Control panel
8. Intake grille
9. Air outlet grille
10. Condenser drain
11. Power cable
ACCESSORIES
Parts Parts name Quantity
Hose inlet
Exhaust hose
Hose outlet + Protective net
1 set
Window slider kit 1 set
Remote Control
Battery
Drain hose 1 set
Foam seal 1 set
4 Bolts
(Metal locking screw)
NOTE:
1 set
4 PCS
All the illustrations in this manual are for explanatory purposes only. Your appliance may be slightly different.
Portable Air Conditioner | 7
Installation Instructions
EXHAUSTING HOT AIR
In the Cool Mode the appliance must be placed close to a window or opening so that the
warm exhaust air can be ducted outside.
First position unit on a at oor and make sure there’s a minimum of 12” (30cm) clearance
around the unit, and is within the vicinity of a single circuit outlet power source.
1. Extend either side of the hose (Fig.1) and screw the hose inlet (Fig.2).
2. Extend the other side of the hose and screw it to the hose outlet (Fig.3).
3. Install the hose inlet into the unit (Fig.4).
4. Attach the hose outlet into the window slider kit and seal (Fig.5&6).
Window slider kit has been designed to t most standard vertical and horizontal window applications. However, it
may be necessary for you to modify some aspects of the installation procedures for certain types of windows. The
Window slider kit can be fastened with screws.
Extend the side of hose
NOTE:
If the window opening is less than the minimum length of the window slider kit, cut on opposite side of the hole
to t the window opening. Never cut the hole on Window slider kit.
Portable Air Conditioner | 8
Loading...