Voyager CVRPS14WI User Manual

CVRPS14WI

Sensor System with Graphic

Overlay

Installation &Operation Manual

Table of Contents:

Installation Manual....................................................Page x thru x

Operations Manual....................................................Page x thru x

Hardware List:

PDC Module OSD Module Sensor x 4 Button

Sensor extension cable x4 Button extension cable Power Cable

Rubber Supporters x 4 Manual

Introduction:

This graphic overlay system to work in conjunction with your camera and
monitor to provide rear parking assistance. There are a number of graphic and
sound options in the setup menu.

Safety Information:

THE SYSTEM IS DESIGNED TO ASSIST YOU IN DETECTING
OBSTACLES AND WILL NOT REPLACE SAFE DRIVING PRACTICE.

2/16

INSTALLATION

REQUIRED TOOLS

Electric Drill Marker Pen Tape Measure SPC5 (1 1/4”)

3/16

POSITION AND MARK BUMPER FOR DRILLING

Connect sensor to the
extension cable through
the supporter.

Rear

Sensor marked
position must on the
upper side when
insert as the figure

INSERT THE SENSORS INTO THE RUBBER SUPPORTERS

4/16

DRILL BUMPER

INSERT SENSORS INTO BUMPER

5/16