Voxx Electronics APS901Z OWNER’S GUIDE

OWNER’S GUIDE

MODEL APS901Z

VOXXELECTRONICS.COM

Table of Contents

Using Your Remote Control ................................................................ 3

Using Your Optional Security System ............................................... 4

Status LED, Light Flashes, and Siren/Horn Indications ..................5

Remote Control Programming ........................................................... 6

Replacing The Remote Control Batteries ..........................................6

Warranty Information ..........................................................................7

2 APS901Z Owners REV.C

Using Your Remote Control

Remote Starting Your Vehicle

To activate the remote start, press and release the button two (2) times. The
vehicle will start and run the predetermined time set up during installation (5 to
60 minutes selectable).

Door Unlock

While the engine is running press, and release and hold the button or three
(3) seconds. Unlock is only available while the vehicle is remote started.

Remote Start Shutdown

Press and release the button two times to turn the vehicle o󰀨. Pressing the
vehicle’s brake will also shutdown the remote start.

Entering the Vehicle while it is Running via Remote Start (Optional)

1. Unlock the vehicle’s doors.

2. Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL!

3. Insert the key into the ignition switch and turn to the ON or RUN
position.

4. Press the brake pedal. The remote starter will disengage and the
vehicle will operate normally.

NOTE: This feature may not be available on all vehicle makes/models. In some
vehicle applications the remote start will shut down upon entering the vehicle
and the engine will stop running. For these applications it will be necessary to
restart the vehicle normally. Refer to installing dealer for details.

Preheating or Precooling the Vehicle’s interior

Before exiting the vehicle, set the temperature controls to the desired setting
and operation. After the system starts the vehicle, the heater or air conditioner
will activate and heat or cool the vehicle’s interior to your setting.

Remote Start Service Mode

For safety, the remote start feature can be disabled to prevent accidental
starting while the vehicle is being serviced.

To engage Remote Start Service Mode

1. Press and hold the valet button.

2. Cycle the vehicle’s ignition ON/OFF three (3) times.

3. Release the valet button.

The LED will begin to ash two (2) short ashes followed by one (1) long ash

to indicate Remote Start Service Mode is active. Repeat steps 1-3 above to
disengage Service Mode.

32020 Voxx Electronics Corporation. All rights reserved.