Voxx Accessories SPKA800 Users Manual

MAIN STAGE

ALL -IN-O NE P A R T Y S Y STE M

QUICK START
GUIDE

Instructions en français ..................................... xx

Instrucciones en español ................................... xx

Step 1: Unpack

Make sure the following items came in this package:

Singsation Main Stage Speaker

and Light Base

ACCESSORIES:

+ Power cable

+ Microphone stand

+ 2 Microphones

+ Device cradle and locking knob

+ Remote control and 2 AA batteries

Step 2: Install batteries in the remote

Remove the battery door from the back of the remote control.

Insert the provided 2 AA batteries in the battery compartment. Make

sure you match the direction of the + and – markings in the compartment.

Put the battery door back on the remote and snap it into place.

2

Step 3: Put the mic stand together

Unfold the microphone stand’s tripod base and tighten the knob in the
center of the base to lock it into place.

Adjust the height of the stand by
turning each clutch counterclockwise

Clutches

Microphone
stand

and lifting the pole to the desired
length.

Make sure to tighten each clutch (turn
clockwise) before you proceed.

Device
cradle,

back

Locking
knob

Microphone
stand

Attach the device cradle to the stand
using the locking knob. Place the
cradle on the top of the stand. Then
insert the locking knob in the hole
on the back of the device cradle and
tighten it until the cradle feels secure.
Do not overtighten!

Step 4: Plug in

Plug the power cable into the POWER jack on the right side
of the Singsation Main Stage base.

Plug the other end of the power cable into a working outlet
or surge protector.

3

Step 5: Turn on

Press and hold the POWER/PAIR
button on the top of the Singsation
Main Stage base (or on its remote)
to turn it on. The Singsation Main
Stage plays its startup sound and
the BLUETOOTH indicator starts
blinking slowly.

Note: If you didn’t hear the startup sound, make

sure the MASTER VOLUME knob is turned up!

After 15–30 seconds, the Singsation
Main Stage announces “Pairing” and
goes to Bluetooth pairing mode to
set up with your Bluetooth device.
The BLUETOOTH indicator starts
blinking faster.

Base

4