Voxx Accessories SP446 Users Manual

WIRELESS SPEAKERS

Welcome to Canz H2O!

These speakers oer two setup options:

Stereo setup for using both
speakers together

Single-Speaker setup for using
each speaker separately

This guide takes you through the steps for
either setup option.

Instructions en français ..............................11

Instrucciones en español ........................... 21

Welcome to Canz H2O!

The best little speakers to go anywhere:
waterproof up to 3ft, and tested to withstand
full submersion for up to 30 minutes! They
even float if they fall in the water! Of course,
we don’t recommend leaving the Canz H2O in or
under water for extended periods of time—but a
little bit won’t do any harm! Just make sure the
back flap covering the USB jack is sealed.

Unpack

Make sure the following items came in this
package:

• (2) H2O speakers • (2) USB charging cables

2

Charge the speakers

Before you start using these speakers for the
first time, it’s a good idea to charge them
completely.

To charge each speaker: Open the CHARGING DC
IN flap on the back of the speaker. Plug one of
the included USB cables into
the jack behind this flap.

Plug the other end of the
USB charging cable into
a power source, like a
computer or a USB charging
adapter.

IMPORTANT: Make sure this
flap is closed if the speaker
is going to get wet.

Speaker back

Flap open

3

Stereo Setup (both speakers together)

1. Turn both speakers on

Press and hold the button
on front of each speaker to
turn it on. The power up tone
sounds and the
starts blinking white on each
speaker.

Wait for the speakers to announce “Left
connected” and “Right connected.”

The button on
the right speaker
turns solid white (it
keeps blinking on
the left speaker).

4

button

Left speaker

Blinking white

Speaker

front

Right speaker

Solid white