AMVXMTG10/VXMTG10
10.1” Overhead LCD Monitor With BuiltIn DVD Player / HDMI & USB Inputs
Installation Guide
®
Important Notices
Installation of overhead products requires careful planning and preparation. Be
extremely careful
wires near any portion of the side curtain air bag assemblies. This includes any
anchor points in A, B, C or D pillars of the vehicle. Routing wires in these areas or
running wires by the side curtain air bags can prevent the side curtain air bag from
fully deploying which can result in personal injury to vehicle occupants. If you
have any questions regarding wire routing in a vehicle, please contact VOXX
Technical Support at 1-800-645-4994.
When connecting power and ground in a mobile video installation, ensure that the ACC
wire is fused at the point where it is connected to the vehicle ACC wiring. Failure to do
so can result in damage to the vehicle if a short circuit develops between the vehicle
connection point and the mobile video product.
An LCD panel and/or video monitor may be installed in a motor vehicle and visible to
the driver if the LCD panel or video monitor is used for vehicle information, system
control, rear or side observation or navigation. If the LCD panel or video monitor is
used for television reception, video or DVD play, the LCD panel or video monitor must
be installed so that these features will only function when the vehicle is in “park” or
when the vehicle's parking brake is applied.
An LCD panel or video monitor used for television reception, video or DVD play that
operates when the vehicle is in gear or when the parking brake is not applied must be
installed to the rear of the driver's seat where it will not be visible, directly or indirectly,
to the operator of the motor vehicle.
when working on a vehicle with side curtain air bags. Do not route
Warnings
• Do not use any solvents or cleaning materials when cleaning the video monitor.
• Do not use any abrasive cleaners, they may scratch the screen.
Use only a lightly dampened lint free cloth to wipe the screen if it is dirty.
Lock the LCD screen in the fully closed position when not in use.
Before putting on headphones always adjust the volume setting to the lowest position.
Remember to leave the dome light switch in the off or auto positions when the vehicle
is unattended, as the dome lights, if left on, can drain
the vehicle's battery.
Do not put pressure on the screen.
Caution children to avoid touching or scratching the screen, as it may become dirty or
damaged.
Patented: Refer to www.voxxintl.com/patents
Safety Precaution
For safety reasons, when changing video media, it is recommended that the vehicle
is not in motion, and that you do not allow children to unfasten seat belts to change
video media or make any adjustments to the system. System adjustments can be
accomplished using the remote control, while seat belts remain fastened. Enjoy your
entertainment system but remember the safety of all passengers remains the number
one priority.
Table Of Contents
Materials Include In This Package .............................................................5
Installing The Unit In A Vehicle .................................................................. 6
Installing The Snap-On Shroud ................................................................ 7
Installing The Snap-On Screen Cover ......................................................8
General Vehicle Installation Approach ....................................................9
Vehicle Preparation ......................................................................................10
Connecting The Dome Lights ..................................................................11
Appendix A - Removing The Screen Back Cover ...............................13
Appendix B - Removing The Shroud ..................................................... 14
Troubleshooting .......................................................................................... 15
Materials Included In This Package
1
2
6
1. 10.1” TFT LCD Overhead Monitor with DVD Player
2. Hardware Package (P/N 540-044)
M5 x 6mm Phillips Screws (P/N 505082)
#8 x 3/8” Self Drilling Screws (P/N 100-2397)
Pry Tool (P/N 100-2424)
Slide Knob for Dome Light Switch (P/N 172-0207)
3. Remote Control w/ Battery (P/N 500-003)
4. 6 Pin Power/Dome Light Harness (P/N 112-4270)
5. AUX Pigtail (P/N 112B3227)
6. 5 Pin AV input Harness (P/N 112-4259)
7. 5 Pin AV output Harness (P/N 112-4260)
8. Snap On Cover (Screen Back) - Shale (P/N 306-288)
- Pewter (P/N 306-289) - (1 pc)
- Black (P/N 306-290) - (1 pc)
9. Snap On Cover (Shroud) - Shale (P/N 306-379)
- Pewter (P/N 306-380)
- Black (P/N 306-381)
10. Installation Guide & Owner’s Manual (Not Shown)
3
- (1 pc)
- (1 pkg)
- (2pcs)
- (4 pcs)
- (1 pc)
- (1 pc)
- (1 pc)
- (1 pc)
- (1 pc)
- (1 pc)
- (1 pc)
- (1 pc)
- (1 pc)
- (1 pc)
- (1 pc)
- (1 of each)
5