LAN DRIVERS INSTALLATION
Making Floppy Disks for NetWare and Windows Installation
You need to use a floppy disk to install the LAN drivers. Use the MAKEDISK.BAT
utility located in the \LAN\I8255X\MAKEDISK directory on the CD.
MAKEDISK [operating system] [destination]
where [operating system] is the OS for which you are creating the
diskette, and [destination] is the drive letter and path (such
as A:). If no destination is specified, the A: drive will be used.
The possible [operating system] options are:
NT = Microsoft Windows NT
W2K = Microsoft Windows* 2000
W9X = Microsoft Windows* 95 and Windows 98
NW = Novel l NetWare servers and clients
DOS = Microsoft DOS and IBM OS2
Make sure you have a 1.44 MB formatted, non-bootable diskette in the floppy
drive when using this utility.
NOTE: The utility MUST be run from the \LAN\I8255X \MAKEDISK directory.
Alternately, you can use the following .BAT files (located
in the root directory on this CD) to simplify this process:
MAKEW9X.BAT -- Creates a drivers disk for Windows 95 and
Windows 98.
Page 10
VGA Features
• IBD69/99 supports C&T 69000 (2MB
embedded)/IBD693/993 supports 69030 (4MB
embedded) VGA controller
• TFT LCD/DSTN LCD/CRT support
• Resolution / Colors / Refresh Rate
1280 x 1024 / 24bits (true color) / 60Hz
(supported by C&T 69030 only)
1280 x 1024 / 256 / 60Hz
1024 x 768 / 16bits (high color) / 85, 75, 60Hz
800 x 600 / 24bits (true color) / 85, 75, 60Hz
• Support drivers for Windows 95/98/NT4.0
Ethernet Features (IBD99/993)
• Intel 82559 Single-chip Ethernet controller
• 10 BaseT/100 BaseTX support, full duplex
• IEEE802.3, IEEE802.3U compliant
• Backward Compatible with Intel 82558
Page 3
Installing the VGA Drivers for Windows 95/98