vo-water duomatik evoline Installation Manual

INSTALLATION GUIDE

soft duomatik

evoline

Before introduction of the softener the installation guide has to be read carefully.

For any disturbances cause by disregarding the instructions evo-water doesn’t accept liability.

evo-water oHG

Falkenstraße 2 72589 Westerheim

Tel.: [phone]

Fax : [phone]

www.evo-water.com

[e-mail]

Safety instructions:

1. Before installation the softener:
Please refer to the corresponding installation – and operation
instructions in this manual.

2. Please refer to the local installation regulations and the general
directives, in particular DIN 1988 and EN1717, also the valid accident
prevention regulations.

3. With not designated use and improper service the manufacturer is
released from any liability.

4. Before the installation please check the statics of the walls, covers and
grounds for loading capacity.
According to place of action a backflow must be installed
corresponding to local regulation before the arrangement.
For the protection of the central tax valves from rust, sand etc. a
suitable mudflap or fine filter should be inserted before the
arrangement. The filter pad of the fine filters should be exchanged
according to DINAR / DVGW at a distance of 6 months or after soiling.
Please ensure that no water damages are caused (e.g., by ground
expiry). The manufacturer is not liable for water damages.
The food water of the arrangement must correspond to the information
of the German drinking water order.
The room temperature must be at least 7°C and may not cross 50°C.

5. Changes in the system may not be made without consultation and
approval with evo-water oHG, for damages no other guarantee is
taken over.

6. The system serves exclusively for the removing of undesirable mineral
substances which retreat as a scale. It serves as a pure system
protection.

1. Parts:

1.

BYPASS

8.

BLENDING REGULATOR

2.

VALVE HOUSING

9.

HARDNESS REGULATOR

3.

RESIN TANK

10.

TO BRINE VALVE

4.

CONTAINER FOR DEVICE AND SALT

11.

CONNECTIONS (1/2",3/4”, 1")

5.

BRINE VALVE (float)

12.

TO DRAIN

6.

WATER INLET

13.

COMMUNICATION TUBES

7.

WATER OUTLET

14.

TUBES TO BRINE VALVE

2. Precautions:

 Make sure you have all necessary tools on hand before you begin with the

installation.

 Follow all local legal regulations.
 Read this manual carefully. If you have any questions or remarks, please

contact your evo-water supplier.

 Check incoming pressure: minimum 1 bar (dynamic), maximum 8 bar (static)

(15 PSI – 116 PSI). If necessary reduce incoming pressure.

 Do not install the evo-water softener close to a heating source (environment

temperature must be below 40°C).

 Protect softener and drain (12) against frost.
 Make sure you have the latest installation manual at hand. Check with your

evo-water supplier.

3. Installation:

3.1 Close main valve and make sure pressure is released from piping. This can be

done by opening at least one tap.

3.2 Connect the two units by means of the provided Y-pieces. You can find them in

the salt compartment. The Y-piece with the filter inside, needs to be mounted
at the inlet of the valve. (= bottom connection) The other must be mounted at
the other connection.

First connect the Y-piece to one unit and afterwards to the other unit. Secure

them with the provided clips (4 pieces). You don’t need to take the units out of
the container to do this.