VOV Heating VHS-3162H Instruction Manual

EN

HEATING

HALOGEN HEATER

Model: VHS-3162H

Instruction manual

Thank you for purchasing the VHS-3162H Halogen Heater. Please read the user’s manual carefully before
using the product. Keep the user’s manual in a safe place further reference.

1. Approved specifications

MODEL NO RATED VOLTAGE RATED POWER
VHS-3162H 230V~50Hz 400/800/1200W

IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE

Warning! To avoid overheating, do not cover the device.

This device is not intended for persons (including children) with reduced physical or mental capabilities, or
those with limited experience and knowledge, if not above them is driven professional supervision or given
instructions involving the use of this device, the person responsible for their safety.
Children should be supervised to ensure that the device will not play.
Do not use without legs installed, if not attached to the wall.
Before connecting the device to an AC outlet, make sure the voltage indicated on the label corresponds to the
voltage in your outlet. Only connect the device to a grounded outlet.
Do not use in the immediate vicinity of bathtubs, showers or swimming pools. Never place the appliance so that
it could fall into a tub or other container with water.
Do not use outdoors.
Do not cover or otherwise obstruct the ventilation holes for air outlet.
Avoid placing the carpet with thick, long fibers.
Always make sure the device is placed on a flat, stable surface. In addition, make sure the device is placed close
to curtains, drapes or furniture, as it would when using the device could cause a dangerous situation.
Do not place the appliance near or below the electrical outlet.
Do not insert any objects into the intake or outlet.
Do not use in environments where flammable substances are present.
If you need to move the unit, first disconnect the power source.
Do not use if the cord is damaged. If the supply cord is damaged, it must be replaced by an authorized service
center or qualified service center to avoid a dangerous situation.
Do not use this device with a programming device, a timer or other device that automatically turns on the
device, because there may be a fire hazard when the appliance is covered or incorrectly placed.

3. Installation

1). Fit the power cable through the center hole of the bottom stand plate.

2). Turn the screws into tight at bottom stand plate and let the plate to be fitted on the body.

3). Fit the clip at the bottom stand plate to fit the power cable.

4. Operating instructions

1). Ensure that the unit is placed on a firm level surface so that the anti overturn switch operates correctly
before using your halogen heater.

2). Insert the power plug into a 220V/50HZ. Power point and switch on.

3). Turn on the power switch to select your desired power. K1 or K2 or K3 for 400W/800W/1200W. Turn on
K4 the unit will oscillate at a range of 90°. All the switches can turn on at the same time.

4). Turn off the power switch and remove the power plug from the point when not in use.

5. Care and cleaning

1). Always switch the heater off and remove the plug from the power point and allow it to cool before cleaning.
To clean the external surface, use a dry or slightly moistened cloth.

2). DO NOT use any solvents. Never probe inside or try to disassemble the heater for cleaning, use a vacuum
cleaner regularly to remove dust and fluff from the grill and lattice net.

3). When not in use store the heater in a cool dry place. Repacking the heater in its original canton provides the
best protection for storage.

According to Waste of Electrical and Electronic Equipment (WEEE) directive, WEEE should be
separately collected and treated. If at any time in future you need to dispose of this product please do
NOT dispose of this product with household waste. Please send this product to WEEE collecting
points where available.

SK

HEATING

HALOGÉNOVÝ OHRIEVAČ

Model: VHS-3162H

Návod na použitie