VOV VWM - 70 Instruction Manual

Twin tub washing machine
VWM - 70
Instruction manual
2
Product despcription
Water falldesign: (selected models only) During washing, the big water-fall flow through the different diections to wash clothes,
it saves wash time and washes clothes cleaner. Hand washing design:
Design for washing cothes for the whole family Super quite design: Adopts low noise & balanced drive system resulting to more quiet operation Fine hair filter design:
Effectively remove lint and hair stand for cleaner clothes Adjustable water level setting
Selectable water current setting
Structure layout Main parts
1. Wash water inlet 6. Wash cover
11. Safety cover
2. Wash timer 7. Wash tub 12. Power cord
3. Wash selector 8. Pulsator 13. Spin cover
4. Spin timer 9. Outer body 14. Spin inner cover
5. Spin water inlet 10. Water inlet hose 15. Drain hose
3
Washing instruction Preparation
1. The machine should be placed on level/flat ground. The bottom air vent of washing machine should be clear from any blockage during operation.
2. This machine uses bipolar plug to assure the safety pipe, gas pipe or heating pipe.
3. Lay down the over flow hose.
4. Use the water hose to connect the water tap to the water inlet.
5. According to the material and weight of clothes, adjust the level of the water.
6. Switch on the power
7. Before washing, operator must separate white clothes from colored clothes.
Washing
1. Put the clothes and correct amount of detergent into the tub ( excessive detergent with make it difficult to get rid of the suds and insufficient rinsing may result)
2. Turn on the water tap to allow water to enter the machine via the water inlet hose. Adjust the water level according to your requirement.
3. Set the wash selector switch to gentle or normal according to the material and weight of clothes.
4. Set the wash timer knob to the proper position and start to wash.
5. After washing, set the wash selector switch to the drain off water.
Spin-drying
1. After draining off water, put the clothes to the spin tub
2. Put down safety lid and spin-dry lid.
3. Set the spin-dry timer to the proper time according to the clothes.
Drain washing
1. After washing, the spin tub can be used to drain your clothes.
2. Drain off excess water from clothes and load into the spin tub-
3. Allow clothes to further drain inside the spin tub for 20-30 seconds before turning on the spin function.
4. Active the spin function to finally remove excess water.
Rinsing
1. Wash tub can also be used rinsing clothes
2. Follow the washing procedure above but not add detergent.
4
ATTENTION
For your safety be sure to connect the ground wire. If the supply cord is damaged, it must be replaced only by Authorized service.
Never put your hand into the wash and spin dry tub which is still in rotation to avoid accidents.
Never wash the textile which contains or have brace of volatile materials.
The timer should be turned clockwise.
When abnormal sound movement is observed during operation, stop the machine as soon as possible.
When washing the water temperature should not be more than 55°C, otherwise it may damage components.
Children should be supervised to ensure that they do not play with appliance
Maintenance
After use out the plug to avoid accident
The machine should not be placed near areas that can easily case fire
Do not put any heavy objects or hot things on the machine
When cleaning the main body with soft cloth be sure not to use rough textile or organic solvent that might damage the finish.
Do not expose the machine outdoor under hot sun or in the damp place such as bathroom.
5
After use
1. Pull the plug out of the socket
2. Discharge the water from the tub
3. Clean the inlet hair filter
4. Hang the drain hose on the side hook
5. Clean the machine with soft cloth
6. Close the lid and place the machine in a well ventilated room
Warning:
This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
If the supply cord is damaged, it must be replaced only by Authorized Hyundai Technician.
Children should be supervised to ensure that they do not play with the appliance.
Main technical parameter
Washing power 135W Frequency 50Hz Spinning capacity 5,5kg Washing capacity 6,8kg Voltage 220~240V Weight 18,3kg/ 20,6kg Measurement (mm) 760 x 430 x 840
Loading...