The product you have purchased is a professional
room ventilating unit for wall or ceiling installation,
with discharge into a single ducting system. All the
models have an IPX4-grade, spray protection, and
are thus ideal for installing in high-humidity
nvironments.
e
L Models
L
The“LL” models have ball bearings that guarantee at
least 30,000 hours of silent, trouble-free mechanical
operation.
T (Timer) Models
This models are equipped with a timer factory-set
fora minimum operating time of 3 minutes. The timer
can be adjuste to settings between approx. 3 and 20
minutes by means of the trimmer (see fig. 20)..The
appliance switches on automatically a few seconds
after the light is switched on and continues to run for
the set time after the light is switched off.
PIR Model
The product is equipped with an electronic circuit
with a sensor (PIR), which brings the unit into
operation when it detects the presence of a person
within its range of action (fig.B: A= Pesence detection
area; B= Blind area). This model is equipped with a
timer factory-set for a minimum operating time of 3
minutes. The timer can be adjuste to settings
between approx. 3 and 20 minutes by means of the
trimmer (see fig. 20).
MHC Model
MHC microprocessor control system
Temperature-humidity comparison
The MHC system is preset to turn on the fan
whenever the ambient temperature is 20°C and the
relative humidity exceeds 65%. When the ambient
temperature is lower than 20°C, the MHC’s intelligent
system turns on the fan when the relative humidity
values are higher.
Adapting to ambient conditions
The MHC has an intelligent memory which allows it to
automatically adapt to the average temperature of the
room in which it is installed. This permits adequate
performance in rooms that are normally warm as well
as in those that are normally cold.
Timer setting
This model is equipped with a timer factory-set for a
operating time of 15 minutes. The timer can be
adjuste to settings between approx. 2 and 30 minutes
by means of the trimmer (see fig. 20).
T-HCS Model
This model has a preset humidity sensing circuit that
switches it on when the relative humidity exceeds
65%. The circuit is also equipped with a timer that
can be adjusted to settings between approx. 3 and 20
minutes by means of the trimmer (see fig. 21). The
unit switches on automatically a few seconds after
the light is switched on and continues to run for the
preset period of time after the light is switched off.
:
:
:
:
:
Safety
Warning:
this symbol indicates that care must
!
be taken to avoid injury to theuser
Do not use this appliance for functions other than
•
those described in this booklet
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician
or Vortice. Do not leave packaging within the reach
of children or infirm persons
• Certain fundamental rules must be observed when
using any electrical appliance, including:
-never touch electrical appliances with wet or
damp hands;
- never touch appliances while barefoot;
- never allow children or infirm persons to operate
appliances unattended.
• This appliance is not suitable for use by children or
by individuals with reduced physical, sensorial or
mental capacities, or by inexperienced or untrained
individuals, unless they are supervised or instructed
in its use by a person responsible for their safety
Children must always be supervised to ensure that
they do not play with the appliance.
• Store the appliance out of the reach of children and
differently able persons after deciding to disconnect
it from the power supply and use it no more.
• Do not us the appliance where flammable vapours
are present (spirit, insecticides, petrol, etc.).
Caution:
this symbol indicates that care must
!
be taken toavoiddamagingthe appliance
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Do not place objects on top of the appliance.
• Regularly inspect the appliance for visible defects. If
the appliance does not function correctly, do not
use it and contact Vortice immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice immediately and
ensure that only genuine original Vortice spares are
used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice
• The appliance must be installed by a professionally
qualified electrician
• The mains power supply to which the units are
connected must comply with current laws.
• The appliance is double insulated and therefore
does not need to be earthed
• The electrical power supply/socket to which the
appliance is to be connected must be able to
provide the maximum electrical power required by
the appliance
• Use a suitably sized multi-polar switch with
9
ENGLISH
minimum contact gaps of 3 mm to install the
appliance.
• Switch off the appliance at the installation's main
witch: a) if the appliance does not function
s
orrectly; b) before cleaning the outside of the
c
ppliance, c) if the appliance is not to be used for
a
any length of time.
Ensure that the room has an adequate source of
•
resh air to ensure correct appliance operation. In
f
the event that other non-sealed combustion-based
appliances (such as water heater or gas stove) are
installed in the same room, check that air
eplacement is sufficient for all appliances to work
r
effectively together.
• The appliance cannot be used to control activation
of water heaters, room heaters, etc. and it must not
exhaust into the hot air flues.
• Ensure that the appliance discharges into a single
duct (dedicated to this product) or directly to the
outside.
• The air to be extracted from the room must be clean
(i.e. free of grease, soot, chemical and corrosive
agents, and explosive or flammable mixtures).
• Do not cover or block appliance intake or outlet
vents grilles as this may prevent optimum air flow.
• T HCS Model: do not cover or obstruct the humidity
sensor grille.
• PIR Model: do not cover the lens of the presence
sensor.
• Specifications for the power supply must
correspond to the electrical data on data plate A
(Fig.A)
N.B.
• If the appliance is installed between a wall and
wall tiling, fit a spacer to compensate for any
level differences to ensure correct operation.
• If the unit is to be mounted on the ceiling,replace
the mylar spring (already fitted to thefan),with
the thicker one contained in theaccessories bag.
(Fig.10)
Installation
Fig. 1-17
Timer setting
ig. 18-22
F
Maintenance / Cleaning
Fig. 23-24
10
ENGLISH
Important information
concerning the environmentally
compatible disposal
IN CERTAIN EUROPEAN UNION COUNTRIES THIS
PRODUCT DOES NOT FALL WITHIN THE
REQUIREMENTS OF THE NATIONAL LAWS
IMPLEMENTING DIRECTIVE WEEE, AND IN
THESE COUNTRIES THE PRODUCT IS NOT
SUBJECT TO SEPARATE DISPOSAL OPERATIONS
AT THE END OF ITS WORKING LIFE.
This product conforms to EU Directive2002/96/EC.
This appliance bears the symbol
of the barred waste bin. This
indicates that, at the end of its
useful life, it must not be disposed
of as domestic waste, but must
be taken to a collection centre for
waste electrical and electronic
equipment, or returned to a
retailer on purchase of a replacement.
It is the user's responsibility to dispose of this
appliance through the appropriate channels at the
end of its useful life. Failure to do so may incur the
penalties established by laws governing waste
disposal.
Proper differential collection, and the subsequent
recycling,processingandenvironmentally
compatible disposal of waste equipment avoids
unnecessary damage to the environment and
possible related healthrisks, and also promotes
recycling of the materials used in the appliance.
For further information on waste collection and
disposal, contact your local waste disposal service,
or the shop from which you purchased the appliance.
Manufacturersandimportersfulfiltheir
responsibilities for recycling, processing and
environmentally compatible disposal either directly or
by participating in collective systems.
ARIETT T
ARIETT LL T
ARIETT LL MHC
ARIETT LL T HCS
N1 L2
3
N
L
15 15
N1
L2
3
16 16
ARIETT LL PIR
1
2
47
17 17
18 18
19 19
48
20 20
ARIETT T
ARIETT T LL
ARIETT LL PIR
ARIETT LL MHC
21 21
ARIETT LL T HCS
22 22
49
23 23
24 24
50
La Vortice S.p.A. si riserva il diritto di apportare tutte le varianti migliorative ai prodotti in corso di vendita.
Vortice S.p.A. reserves the right to make improvements to products at any time and without prior notice.
La société Vortice S.p.A. se réserve le droit d'apporter toutes les variations afin d'améliorer ses produits en cours de commercialisation.
Die Firma Vortice S.p.A. behält sich vor, alle eventuellen Verbesserungsänderungen an den Produkten des Verkaufsangebots vorzunehmen.
Vortice se reserva el derecho de incorporar todas las mejoras necesarias a los productos en fase de venta.
A Vortice S.p.A. reserva-se o direito de efectuar melhorias nos produtos comercializados.
Vortice S.p.A. förbehåller sig rätten att under försäljning tillföra alla ändringar som förbättrar produkterna
Firma Vortice zastrzega sobie prawo wprowadzania wszelkiego rodzaju ulepszeń do urządzeń znajdujących się w sprzedaży.
A Vortice S.p.A. fenntartja a jogot, hogy az értékesítés alatt álló termékeknél bármilyen javító változtatást bevezessen.
Podnik Vortice a.s. si vyhrazuje právo na zlepšování svých výrobků v průběhu prodeje.
Firma Vortice S.p.A.îţi rezervădreptul de a aduce îmbunătăţiri produselor în vânzare.
Tvrtka ''Vortice S.p.A.'' zadržava pravo unošenja promjena u svrhu poboljšanja proizvoda u prodaji.
Η Vortice S.p.A διατηρεί το δικαίωµα να πραγµατοποιεί βελτιωτικές τροποποιήσεις στα προϊόντα της που βρίσκονται στην αγορά.
52
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.