Vortex Pulse User Manual

PULSE - USER MANUAL

FCC ID: 2ADLJPULSE

The device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.

1.0 OVERVIEW

Thank you for choosing the WCDMA/GSM digital mobile phone. After reading this guide you
will be able to fully master the use of your phone and appreciate all its functions and ease of
use. Not only does the smartphone provide you with basic call functions such as call Register,
but also with many practical functions and services, to improve the time you spend working
and playing. The color screen mobile phone complies with the WCDMA/GSM technology and
has been approved by certification authorities both domestically and abroad. The availability
of some services and features described in this manual depends on the network and your
subscription. Therefore, some menu items may not be available in your phone. The shortcuts
to menus and features may also vary from phone to phone. Our company reserves the right
to revise this manual content without prior notice.

1.2 SAFETY GUIDE

If your mobile phone is lost or stolen, please contact the telecommunications authorities or a
sales agent immediately to have a hold on the phone and the SIM card. This will prevent
economic loss caused by unauthorized calls made from your mobile phone. When you
contact the telecommunications authorities or a sales agent, they will need to know the IMEI
number of our mobile phone (remove battery to expose number located on the label on back
of phone). Please copy this number and keep in a safe place for future use. In order to avoid
the misuse of your mobile phone please take the following preventative measures: Set the
PIN number of your mobile phone’s SIM card and change this number immediately if it
becomes known to a third party. Please keep the phone out of sight when leaving it in a
vehicle. It is best to carry the phone with you, or lock it in the trunk.
Set call barring.

1.3 SAFETY WARNINGS AND NOTICES

Before using your mobile phone, read and understand the following notices carefully to
ensure you will use it safely and properly.

1.3.1 GENERAL ATTENTION

Only the battery and battery charger specified by our company should be used in your phone.
Other products might result in battery leakage, overheating, fire or explosion. To avoid your
phone malfunctioning, or catching fire, please do not violently impact, jolt or throw your
phone. PLEASE do not place the battery, mobile phone, or charger in a microwave oven or
high-pressure equipment. Otherwise it could lead to unexpected accidents such as damage
to the circuitry or fire hazard. PLEASE do not use your phone near flammable or explosive
gases, otherwise it could cause malfunction of your phone or fire hazard. Please do not
subject your phone to high temperatures, high humidity or dusty places; otherwise this may
lead to the malfunction of your phone. Keep your phone out of the reach of small children.
Your phone is not a toy. Children could hurt themselves. To avoid your phone falling and
malfunctioning or being damaged, please do not place it on uneven or unstable surfaces.

1

1.3.2 NOTICES WHEN USING YOUR PHONE

Turn off your mobile phone where the phone is not allowed, such as, on the airplane or in
hospitals. Using the mobile phone in those places may impact the normal operation of
electronic devices and medical instruments. Follow relevant regulations when using your
mobile phone in those places. Your mobile phone has the auto turn-on feature. Check your
alarm clock settings to confirm that your mobile phone will not be turned on automatically
during flight. Please do not use your mobile phone near the weak signal or high precision
electronic devices. RF interference might cause malfunctioning of such electronic devices and
other problems. Special tips must be paid near the following equipment: hearing aids, pace
makers and other medical electronic devices, fire detectors, automatic doors and other
automatic control installations. To find out the effect of mobile phones on a pacemaker or
other pieces of electronic medical equipment please contact the manufacturers or local sales
agents of the equipment. Please do not subject the LCD to impact or use the screen to strike
things, as this will damage the LCD board and cause leakage of the liquid crystal. There is a
risk of blindness if the liquid crystal substance gets into the eyes. If this occurs rinse eyes
immediately with clear water (under no circumstances rub your eyes) and go immediately to
a hospital for treatment. Do not disassemble or modify your mobile phone, as it will lead to
damage to the phone such as battery leakage or circuitry failure. Under very rare
circumstances using the mobile phone in certain model cars may negatively affect the internal
electronic equipment. In order to assure your safety under such circumstances please do not
use the mobile phone. Please do not use needles, pen tips, or other sharp objects on the
keypad as this may damage the mobile phone or cause it to malfunction. In the event of
antenna malfunction, do not use your phone, as it could be harmful to human body. Avoid
letting the phone come into close contact with magnetic objects such as magnetic cards as
the radiation waves of the mobile phone may erase the information stored on floppy disks,
pay cards and credit cards. Please keep small metal objects, such as thumbtacks far away
from the receiver. When the receiver is in use it becomes magnetic and may attract these
small metal objects and thus these may cause injury or damage the mobile phone. Avoid
having the mobile phone come into contact with water or other liquids. If liquids enter the
phone, this could cause a short circuit, battery leakage or other malfunction.

1.3.3 NOTICES WHEN USING THE BATTERY

The battery has a limited service life. The remaining life gets shorter as the times of charging
increase. If the battery becomes feeble even after the charging, this indicates the service life
is over and you have to use a new battery. Do not dispose of old batteries with everyday
domestic garbage. Please dispose of old batteries at the directed places with specific rules
for their disposal. Please do not throw batteries into a fire, as this will cause the batter to
catch fire and explode. When installing the battery, do not use force or pressure, as this will
cause the battery to leak, overheat, crack and catch fire. Please do not use wires, needles or
other metal objects to short-circuit the battery. Also, do not put the battery near necklaces or
other metal objects, as this will cause the battery to leak, overheat, crack and catch fire.
Please do not solder the contact points of the battery, as this will cause the battery to leak,
overheat, crack and catch fire. If the liquid in the batteries goes into the eyes, there is a risk
of blindness. If this occurs do not rub the eyes, but immediately rinse eyes with clear water
and go to the hospital for treatment. Please do not disassemble or modify the battery, as this
will cause the battery to leak, overheat, crack and catch fire.

2

Please do not use or place the batteries near high temperature places such as near a fire or
heating vessel, as this will cause the battery to leak, overheat, crack and catch fire. If the
battery overheats, changes color, or becomes distorted during use, charging, or storage,
please stop using and replace it with a new battery. If the liquid from the battery comes in
contact with skin or clothing this could cause burning of the skin. Immediately use clear water
to rinse and seek medical tips if necessary. If the battery leaks or gives off a strange odor,
please remove the battery from the vicinity of the open fire to avoid a fire or explosion.
Please do no let the battery become wet as this will cause the battery to overheat, smoke and
corrode. Please do not use or place batteries in places of high temperature such as in direct
sunlight, as this will cause the battery to leak and overheat, lower performance, and shorten
the battery’s life. Please do not continuously charge for more than 24 hours.

1.3.4 CHARGING YOUR PHONE

Connect the connector of charger to the mobile phone. The battery level indicator flashes on
the screen. Even if the phone has been turned off, the charging image still appears, indicating
that the battery is being charged. If the phone is overused when the current is insufficient, it
may take longer time for the charging indicator to appear on the screen after the charging
begins. When the battery level indicator does not flash and indicates the battery is full, this
indicates the charging has been completed. If the phone is off during charging, the charging
being completed image also appears on the screen. The charging process often takes 3 to 4
hours. During the charging, the battery, phone and charger gets warm, this is a normal
phenomenon. Upon the completion of charging, disconnect the charger from AC power
socket, and from the mobile phone.

NOTES: During charging, the phone must be placed in well-ventilated environment of

＋5℃ ~ ＋40℃. Always use the charger supplied by your phone manufacturer. Using an

unauthorized charger might cause danger and invalidate the authorization and warranty
clauses for your phone.
The standby time and call duration provided by the manufacturer are based on ideal
operating environment. In practice, the battery's operating time varies depending on
network conditions, operating environment and usage methods. Make sure the battery has
been installed before charging. It is best not to remove the battery while charging. Upon
completion of charging, disconnect the charger from your phone and the power supply.

If you have not disconnected the charger from your phone and the power supply, the

charger will continue to charge the battery after about 5 to 8 hours when the batter level
decreases substantially. We advise you not to do like this, as it lowers your phone
performance and shortens your phone life.

Notices when using your charger. Please use AC 220 volts. The use of any other voltage will
cause battery leakage, fire and cause damage to the mobile phone and charger. It is
forbidden to short circuit the charger, as this will cause electrical shock, smoking and damage
to the charger. Please do no use the charger if the power cord is damaged, as this will cause
fire or electrical shock. Please immediately clean any dust gathered on the electrical outlet.
Please do no place vessels with water near the charger in order to avoid water splashing onto
the charger and causing an electrical shortage, leakage or other malfunction.

3

If the charger comes in contact with water or other liquid the power must immediately be
switched off to avoid an electrical short or shock, fire or malfunction of the charger.
Please do not disassemble or modify the charger, as it will lead to bodily harm, electrical
shock, fire or damage to the charger. Please do not use the charger in the bathroom or other
excessively moist areas, as this will cause electrical chock, fire or damage to the charger.
Please do not touch the charger with wet hands, as this will cause electrical shock.
Do not modify or place heavy objects on the power cord, as this will cause electrical shock or
fire. Before cleaning or carrying out maintenance please unplug the charger from the
electrical outlet. When unplugging charger, do not pull on the cord, but rather hold on to the
body of the charger, as pulling on the cord will damage the cord and lead to electrical shock
or fire.

1.3.5 CLEANING AND MAINTENANCE

The mobile phone, battery, and charger are not water resistant. Please do not use them in the
bathroom or other excessively moist areas and likewise avoid allowing them to get wet in the
rain. Use a soft, dry cloth to clean the mobile phone, battery and charger. Please do not use
alcohol, thinner, benzene or other solvents to wipe the mobile phone. A dirty outlet will cause
poor electrical contact, lose of power and even inability to recharge. Please clean regularly.

2.0 GETTING STARTED

2.1.1 TO INSTALL THE APPLICATION

Native support extended application, can be installed applications for APK file format.
Installation requires, first of all, for the first time in the "Settings - application" will check the
item "unknown sources".
.. Network to download:
.. Through the application of the computer to download to install the APK.
.. The APK file copy into the phone T card.
Select "document management" in the mobile phone found an APK file, found to
install the application, directly touch points to start the installation.
.. Mobile phone Online to Download:
Through mobile phones the AP store download Online application, you first need to install in
the mobile phone electronic market clients. For example: play, baidu mobile application
stores, etc.
.. Into the APP store, find the need to program, click download, and system will be
prompted to install after the download is complete

2.1.2 ICONS

In the standby mode, the following icons may appear in standby screen:

4

ICON DESCRIPTION

Indicate the intensity of network signals.

Show missed calls.

Location by satellite.

Receive a new message.

An application is being downloaded.

The downloading is over

The alarm clock has been set and activated.

A call is in progress.

The phone is playing a song.

Show battery level

Enable USB.

The access is blocked

Get connected to the wireless network

Turn on the Bluetooth

No SIM card is installed in the phone.

GPRS data connection is on.

5