Voodoo Lab PX-8 PLUS User Manual

PX-8 PLUS

PEDAL SWITCHING SYSTEM

User’s Manual

voodoolab.com

Copyright ©2015-2017 by Digital Music Corporation.
This publication is protected by copyright and all rights are reserved.
Voodoo Lab, Pedal Power, Ground Control and Dingbat are trademarks of Digital Music Corp.

rev 0.9 5/2017

TABLE OF CONTENTS

OVERVIEW 3

DESCRIPTION 3
Top Panel
Rear Panel

CONNECTIONS 4
Power
Audio Loops
MIDI

OPERATION 5
Preset Method
Loop Strip Method
Using Ground Control Pro

SETUP 7
Select Preset or Loop Strip Method
Quiet Switching
MIDI > Enable Message Types
MIDI > Set Channel
MIDI > Control Change Number
Factory Reset

WARRANTY 11

OVERVIEW

The Voodoo Lab PX-8+ is a programmable 8-loop audio switcher that provides total
control over guitar pedalboards. It's basic function as an exceptional quality true-bypass
loop strip removes all unused cabling and connections from the signal path for
noticeably improved tone and dynamics.

Simple and intuitive programming allows guitarists to create 36 preset combinations of
effects for instant one-button recall. Each PX-8+ preset also sends a MIDI command to
select programs on MIDI-capable effects, like digital delay and reverb. Adding the
Voodoo Lab Control Switcher gives you control of amp functions, like channel switching,
boost, EQ and more, to create a complete automation solution for most live rigs.

PX-8+ is also available integrated with Voodoo Lab's innovative and patent pending
Dingbat PX Pedalboards. The unique mounting of these pedalboards puts PX-8+ and all
its cabling underneath, leaving the valuable top surface area clear for more pedals.

The world leader in power and switching for guitar rigs, Voodoo Lab has produced
electronics for professional musicians since 1986. All Voodoo Lab products are
designed and manufactured to the highest standards in Santa Rosa, California.

DESCRIPTION

Top Panel

IA:

Select between Preset and Instant Access modes.

SAVE: Press and hold to save preset.

Preset mode only (All LEDs green):

BANK  and :

Select banks 1-9.

A, B, C, D: Recall presets.

Instant Access mode only (All LEDs red):

BANK  and :

Sets instant access bank to Low (loops 1-4) or High (loops 5-8).

A, B, C, D: Toggle loops on and off.

3