Installation Guide
VONN Lighting
Model: VMC31620
LED INFO & WARNINGS
Please read and comprehend the entire manual before attempting to
•
assemble, operate, or install the product.
Make sure that you have all necessary parts by checking the parts list. If
•
any part is missing or damaged, please contact VONN Lighting
Customer Service at 888-604-8666 for a replacement.
All parts must be used as indicated in these instructions. Do not substitute
•
any parts, leave parts out, or use any parts that are worn or broken.
Inspect the LED fixture prior to installation to make sure that it has not
•
been damaged during shipping.
•
Please handle the LED light with care when unpacking. Do not apply
pressure to the LEDʼs, do not open any factory sealed compartments, and
do not touch the LEDs with your hands.
VONN highly recommends to use a qualified, licensed electrician to install
the fixture.
•
VONN recommends to install the fixture on its own independent circuit.
Do not install the fixture on the same circuit with other appliances, or
HVAC systems.
Do not remove or replace VONN manufactured driver that is provided
•
with the fixture.
DO NOT CUT WIRES attached to the fixture under any circumstance.
Cutting wires will VOID your warranty. Excess cable should be neatly
looped and tucked into the canopy.
•
Please remove the canopy from the box prior to the fixture body. Failure
to do so can potentially lead to cables getting tangled.
•
VONN recommends ELV (Electric Low Voltage) type dimmers for this
fixture.
•
Shut “OFF” the electricity at main fuse box.
•
Place the wall switch in the “OFF” position of the room you are installing
the fixture.
Parts List
A.
A
B
C
E
D
F
G
Mounting Bracket
B.
Plastic Anchors x 3
C.
Anchor Screws x 3
D.
Outlet Screws x 3
E.
Wire Connectors x 3
F.
Ground Screw x 1
G.
Canopy Screws x 2
Circuit Box
ON
Tools You May Need
GOGGLES
TAPE MEASURE
RUBBER
GLOVES
PHILLIPS
SCREW DRIVER
DRILL
LADDER
© VONN Lighting,2017