Von Duprin 99, 98 Installation Instructions Manual
98/99
911373-00
Rim Exit Device Installation Instructions
#10-24
Dogging Key
(use to lock down pushbar)
Customer Service
1-877-671-7011 www.allegion.com
© Allegion 2014
Printed in U.S.A.
911373-00 Rev. 01/14-e
SCREW CHART
Device Subassembly
499F Strike299 Strike
Packaged with 990 Trims:
Screw Application
#10-24 x ³⁄₄” (19 mm)
#10 x 1¹⁄₂” (38 mm) Wood screw
#10-24 x 1” (25 mm)
#10-24 x 1¹⁄₂” (38 mm) Sex bolts, 2¹⁄₄” (57 mm) door
#10 x 1¹⁄₄” (32 mm) Wood screw
#10-24 x 1³⁄₈” (35 mm) 1³⁄₄” (44 mm) door, 990 Trim
#10-24 x 1⁷⁄₈” (48 mm) 2¹⁄₄” (57 mm) door, 990 Trim
Metal frame
Wood frame
Surface mount or Sex bolts
1³⁄₄” (44 mm) door
Surface mount (wood)
#10-24 x ³⁄₄” (19 mm)
#10-24 x 1¹⁄₈” (29 mm) Sex bolts, 2¹⁄₄” (57 mm) door
#10 x 1¹⁄₄” (32 mm) Wood screw
#10-16 x ³⁄₈” (10 mm) Thread cutting
#10-24 x 1” (25 mm) Surface mount (metal)
#10 x 1¹⁄₄” (32 mm) Wood screw
Surface mount or Sex bolts
1³⁄₄” (44 mm) door
Surface mount (wood)
End cap
Surface mount (wood)
#8-18 x ³⁄₈” (10 mm) Thread cutting
Center case cover
2
* 39¹³⁄₁₆” (101.1 cm)
from fi nished fl oor
RHR
RHR LHR
For double doors with a
*
mullion and strike already
installed, use existing
strike center line.
2 Prepare 2 holes and install 2 screws.
Q See “Screw Chart” on previous page for screw types and
sizes
1 Align strike on
C
and mark the two slotted
L
holes.
Q For 499F strike installation, see page 6.
Roller
(against door)
OR
299
299F
Metal
#25
#10-24
OR
Wood
¹⁄₈” (3 mm) x 1” (25 mm) deep
3 Position template against strike and on C
mark door.
Mark Vertical C
and
L
L
Q For more information on the strikes shown below, go to
http://w3securitytechnologies.com and look for the
Support area for Von Duprin installation instructions.
1439 1609
264 1606
Mark 6 holes
4 If necessary, prepare cutouts for cylinder and trim.
RHR shown, LHR opposite
For trim applications
For outside cylinder applications:
Mark with template and cut out
Metal door (cut device side)
Wood door (cut thru)
with working lever,
thumbpiece, or knob:
Mark with template
and cut out (cut
device side only)
3
Loading...