Voltminder Voltminder Owner's Manual

THANK YOU FOR PURCHASING THE VOLTMINDER!

We sincerely appreciate your business. We are confident that you will be happy that you
now own a Voltminder. If you have any comments or questions about the Voltminder,
please do not hesitate to contact us:

Email [e-mail]

Phone [phone]

Mailing address:
Voltminder Inc.
165 Applecross LN
Pottsboro TX 75076

LIMITED WARRANTY

Voltminder Inc. warrants your unit to be free from defects in material and workmanship,
excepting abuse or misuse, for a period of ninety (90) days from the date of the sale to the
original user or consumer purchaser.
This warranty is non-transferable. If your unit malfunctions or fails with the warranty
period because of a defect in material or workmanship, Voltminder Inc. will replace or
repair the unit (at our discretion). Replacement will be made with a new or
remanufactured product or component. If the product is no longer available, replacement
may be made with a similar product of equal or greater value.

This warranty is in lieu of all other express warranties. The duration of any implied
warranty, including but not limited to any implied warranty or merchantability or fitness
for a particular purpose, made in respect to your unit is limited to the period of the
express warranty set forth above.

For warranty service, please send an email to [e-mail], or to our mailing
address: Voltminder, 165 Applecross LN, Pottsboro TX 75076.

If a warranty return is necessary, a proof of purchase is required. Voltminder Inc. is not
responsible for shipments delayed or lost in transit.

In no event shall Voltminder Inc. be liable for consequential or incidental damages.
Some states do not allow limitations on the length of the implied warranty or the
exclusion or limitations of incidental or consequential damages, so the above limitations
or exclusions may not apply to you. This warranty gives you specific legal rights and
you may have other rights, which may vary from state to state.

If you have any technical questions, please send inquiries by email to
[e-mail]

1 www.VoltMinder.com

IMPORTANT: In order for the Voltminder to work, the power outlet must be “hot”
(energized) at all times, even when the vehicle ignition is turned off. The alarm will
remain at the level that you had previously set regardless of how many times you connect
and disconnect the unit. Be sure to read through the Owner’s Manual completely prior to
installation. This also applies if you chose to “hard wire” your Voltminder rather than
using the power outlet.

INSTALLATION

Voltminder packaging includes:

Voltminder unit –1
Voltminder power cord - 1
Velcro Strips – 2
Mounting screws – 4
Wire twists (for use if hardwiring) - 2

The Voltminder can be mounted to a flat surface using the 4 mounting screws or behind a
flat surface that has a hole cut in it to allow viewing the display and controls. Other
mounting options are acceptable as long as there is room for the power cord. Please visit

www.VoltMinder.com for a video about mounting options.

>>> USE OF A PROPERLY SIZED FUSE IS REQUIRED FOR SAFE
OPERATION OF THE VOLTMIDER <<<

The Voltminder must have a properly sized fuse at the point that it is connected to the
voltage source. Voltminder Inc. does not accept any responsibility for any damage
caused by missing, improperly sized, or inoperable fuses.

OPERATING INSTRUCTIONS

1. When first turned on, a “beep” will sound for approximately 5 seconds.

2. Press/release the “BACK LIGHT” button to increase the LCD brightness (after 4
presses, the brightness will return to it’s lowest setting)

3. Press/release the “MODE” button to put the Voltminder into “Set Alarm” mode

4. Press/release “ON” and “OFF” buttons to adjust alarm voltage up (ON) or down
(OFF) by .05 volts per click.

5. When the desired alert voltage is displayed, Press/release the “MODE” button to
exit the “Set Alarm” mode

6. Press/release ON to activate the alarm

2 www.VoltMinder.com