Thank you for choosing Volta vacuum cleaner. To ensure total
satisfaction, read this Instruction book carefully.
Retain for reference.
U 5001
Please keep both flaps open when reading these operating
instructions.
I. Tools for your Vacuum Cleaner
C
Dust bags
C Telescopic tube
D
Swivel hose and handle with manual suction control
E
Combination carpet/hard floor nozzle
G
Narrow crevice nozzle
H
Upholstery nozzle
I
Dusting brush
J
Small tool holder
II. Ensuring your safety
The Vacuum Cleaner is for domestic use only and has been
designed to ensure maximum safety and performance.
Please follow these simple precautions:
L
The Vacuum Cleaner is double-insulated so it must
not be earthed
M
The Vacuum Cleaner is only to be used by adults
N
Always store in a dry place
O
Do not use to pick up liquids
P
Avoid sharp objects
Q
Do not pick up hot cinders or lighted cigarette ends
R
Do not use near flammable gases
S
Avoid tugging on the mains cable and check cable
regularly for damage
T
Note: Do not use cleaner with a damaged cable.
If damaged the cable should be replaced at an
Electrolux Service Centre
U
The plug must be removed from the socket-outlet
before cleaning or maintaining the appliance
W
All service and repairs must be carried out by
authorised service staff
III. Getting Started
1 •
Check the dust bag is in place.
2 •
Insert the hose until the catches click to engage.
(Press catches inwards to release).
3 •
Attach telescopic tube to the hose handle and floor
nozzle by pushing together.
(Pull apart to dismantle.)
4 •
Extend the cable and connect to mains. The Vacuum
Cleaner is fitted with cable rewind, ensure cable is not
twisted before use (Press foot pedal to rewind.
Note:
Please hold the plug to prevent it striking you or
the machine
).
5 •
Press the On/Off button to activate the cleaner.
IV . Your Vacuum Cleaner features
AXMains cable
B
Y
Cable rewind pedal
C
d
Mechanical dust bag indicator
D
e
Hose connection
E
f
Dust bag security device – prevents lid closing
without a dust bag in place
F
E
Carrying Handle
G
h
Cover release catch for dust bag compartment
H
i
On/off switch
I
j
Storage slot for floor nozzle and extension tubes
when in use
J
k
Storage slot for floor nozzle and extension tubes
when not in use
K
J
Tool holder (for attachment to hose handle or
extension tube) with slot for wall mounting
Getting the best results
n
Carpets: Use the floor nozzle with the lever in
this position
o
Hard floors: Use the floor nozzle with the lever in
this position
p
Loose rugs/curtains/lightweight fabrics: Reduce
the suction power. Use the floor nozzle for loose rugs
and the upholstery nozzle for curtains, cushions etc.
r
Confined areas: Use the crevice nozzle for crevices,
corners and radiators.
Dust bag indicator and changing the dust bag
For peak performance the dust bag must be changed
when full. If the dust bag breaks in the cleaner, the
Vacuum Cleaner must be taken to an Authorized
Service Centre for cleaning. The dust bag indicator
window will gradually turn red when filling and
completely red when full.
To check the dust bag, the cleaner must be switched
on, with all attachments connected and off the floor.
The dust bag full indicator may signify that the bag is
blocked (occasionally caused by very fine dust)
which will cause loss of suction and may result in
overheating. If this occurs change the dust bag even
if it is not full.
To change the dust bag:
A Release catch and swing back lid before removing
the dust bag, bend the tab into the hole to prevent
dust escaping
B Remove the dust bag
C Insert new dust bag by fitting the bag slots over
holder.
We recommend the dust bag is changed:
*
after using a carpet cleaning powder.
*
if there is a bad smell from the cleaner, then you
should also change the filter.
Note: use only original dust bags and filters.
Dust bag safety device
To avoid damaging the cleaner, do not use it without
a dust bag. A safety device is fitted which prevents
the cover closing without a dust bag. Do not attempt
to force cover shut.
Changing/Cleaning the filters
These should be changed every fifth dust bag. Never
use the cleaner without the motor protection filter.
To change filters:
a) Lift lid, remove dust bag and filter
b) Insert new filter, replace dust bag and close.
There is also an exhaust filter.
To change it:
a) Lift rear grill and remove filter
b) Insert new filter and replace grill.
Troubleshooting
1. Power: If the electric power does not come on,
disconnect from mains and check plugs, cable and
fuses where appropriate.
2. Blockages/dirty filters: The cleaner may switch
itself off in the event of a severe blockage or
excessively dirty filter(s). In such cases, disconnect
from mains and allow to cool for 20-30 minutes.
Clear blockage and/or replace filter(s) and restart.
If the safety valve triggers repeatedly during normal
use, check and remedy and blockage in the hose,
tubes nozzle or filters.
The cleaning of blocked hoses is not covered by the
guarantee. To avoid blockages and maintain suction
efficiency, the floor nozzles should be cleaned
regularly using the hose handle.
3. Water: If water is sucked into the cleaner the motor
must be changed at an Authorized Service Centre.
Volta decline all responsibility for all damages arising from
any improper use of the appliance or in case of tampering
with the appliance.
Volta reserve the right to alter product appearance and/or
specifications without notice. Not all models featured are
available an all countries.
Volta vacuum cleanerfeatures and accessories are protected
wolrdwide by Patents or Registered Designs.
This product, designed with the enviroment in mid,
uses recycled materials where possible.
Thank you purchasing your Vacuum Cleaner and we trust it will give you many years of statisfactory service.
To keep your cleaner operating at th elevel of effinency for which it was recommend you use only Genuine Dust
Bags, Filters, and Accessories. These should be available from the retail outlet where you bought the cleaner.
Should you experience any problems purchasing Genuine Parts, please call the following number for assistance:
1 300 366 366 (Australia only)
050 873 0730 (New Zealand only)
11/98
TCF
ANY PROBLEMS?
DON’T TAKE IT
BACK TO THE SHOP
Something missing?
Don’t understand
We are only
a telephone
call away.
the instructions?
Need more help?
CUSTOMER HELPLINE
1 300 369 333
050 873 0730
(Local call cost Australia wide)
(Free call New Zealand wide)
2190240-12
Loading...