Volt VAL-9501-4036-BBZ Installation Instructions Manual
VOLT® Low Voltage Landscape Lighting
VOLT
®
Tranquility Brass LED Hanging Light
VAL-9501-4036-BBZ
INSTALLATION INSTRUCTIONS
Specications and product details subject to change without notice.
© Copyright 2018, VOLT® Lighting, Lutz FL USA 33549 • All rights
reserved. customersupport@voltlighting.com • 813.978.3700
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)
VOLT® Tranquility Brass LED Hanging Light
VAL-9501-4036-BBZ
INSTALLATION INSTRUCTIONS
www.voltlighting.com
Important: Please Read Before Installation
!
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
1. Make sure that the power is turned OFF before installing or servicing this
luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or
more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with wire connectors that are suitable
for outdoor use.
5. The unit low voltage cable should:
a) Be protected by routing in close proximity to the luminaire or
tting, or next to a building structure such as a house or deck;
b) Not be buried except for a maximum 6 inches (15.2 cm) in order to
connect to the main low voltage cable; and
c) Have the length cut o so that it is connected to a connector within
6 inches (15.2 cm) from the building structure, a luminaire, or tting.
6. If additional lengths of low voltage cable are required, please contact
www.voltlighting.com or call 1-813-978-3700.
Important Safety Instructions
!
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn o/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage lamp.
6. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
Package Contents
A. (1) Fixture Body
B. (1) Fixture Chain
C. (1) Quick Link
D. (1) Mounting Bracket
Product Dimensions
2.2”
5”
5.4”
6.6”
Parts Required (sold separately)
A. (3) Self-tapping Screws
B. (3) Wall Anchors
C. (3) Flat Washers
D. (1) LED MR16 Lamp
E. (1) Low Voltage Transformer
F. (1) Exterior Grade Caulk
Loading...